Speco Technologies VL-12 Series User Manual

CONTENTS
VL-12 Series Weatherproof IR Color Camera with Extreme Adjustability – Wall & Ceiling Mount
200 New Highway. Amityville, NY 11701
1-800-645-5516 FAX:631-957-9142
www.specotech.com
CONTENTS……….…………………………………………..………………. 2
SAFETY PRECAUTIONS………………………………………................. 3
2
SAFETY PRECAUTIONS
Please read before using
1. Please read the service manual before using.
2. Do not disassemble the camera-no user serviceable parts inside
3. The product is IP-66 rated.
4. Do not attempt to service the unit yourself unless you are authorized to do so. Opening cover may expose you to dangerous voltage or other hazards. Refer all servicing to qualified personnel only.
5. Turn off the power before cleaning the camera body; use only a clean damp cloth. Do not use any soap or cleaners.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of insulated dangerous Voltage within the product’s enclosure that may be sufficient magnitude to constitute risk of electrical shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying the appliance.
3
FEATURES
AWB: The camera includes auto white balance mode and auto capture color temperature. The range is 2400k~9400K
CDS:The IR LED only activates when needed.
Illumination is 4 LUX±2LUX (LED on) / 8LUX±2LUX(LED off)
CDS SENSOR
LENSSuper sensitivity BOARD LENS for optimum low light pictures..
IR LEDSuper power LED IR lightwavelength i s 840n m for max imum
illumination.
LENS
IR LEDS
4
Power and video connections Power: Regulated 12 Volts DC, center pin is positive (+) Video: BNC, 1 Volt p-p
BNC Video Output
DC Power
5
Pan-Tilt-Twist (P-T-T) : Adjustable Manual X-Y-Z position
Pan: 360 degree Tilt : 150 degree Twist : 360 degree turning (one turn only)
Twist : 360 degree Pan: 360 degree
Grasp the front ring of the hosing and twist as required to make the
picture straight.
Tilt: 180 degree
6
INSTALLATION
base
body
Step 1
Loosen the set screw and remove the base
Step 2
Attach the base to the wall or ceiling.
Step 3
Line up the set screw on the body to the slot on the base.
Screw 3
Screw cover
Screw 1
Screw 2
Step 4
Attach the body to the base
Step 5
Adjust the angel then tighten screw 1,2 & 3.
7
8
Loading...
+ 1 hidden pages