Speco Technologies VL-11, VL-10 User Manual
CONTENTS
panying
VL-10 AND VL-11
IR CCD WATER RESISTANT
COLOR CAMERA
200 New Highway. Amityvill, NY 11701
1-800-645-5516 FAX:631-957-9142 or 631-957-3880
www.specotech.com
CONTENT……….…………………………………………..………………. 2
SAFETY PRECAUTIONS………………………………………................. 3
FEATURES…………………………………………………………………… 4
CDS …………………………………………………..……………. 4
AWS ………………………………………..……………………… 4
IR LENS ………………………………..………………………….. 4
Mount….………………………………………………………….. 5
Sunshade………………………….……………………………….. 5
Power and Video Output Jack…………………………………… 5
INSTALLATION……….. …………………………………………………….. 6
SPECIFICATIONS …….…………………………………………………….. 7
DIMENSIONS………………………………………………………………... 8
2
SAFETY PRECAUTIONS FEATURES
Please read before using
1. Please read the service manual in details before using.
2. Do not disassemble the camera-no user serviceable parts inside
3. The product is IP-66 waterproof rated.
4. Do not attempt to service the unit yourself unless you are
5. Turn off the power before cleaning the camera body; use only a
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of insulated dangerous Voltage within the
product’s enclosure that may be sufficient magnitude
to constitute risk of electrical shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operation and maintenance (servicing) instructions in
the literature accom
authorized to do so. Opening cover may expose you to
dangerous voltage or other hazards. Refer all servicing to
qualified personnel only.
clean damp cloth. Do not use any soap or cleaners.
the appliance.
3
AWB: The camera includes auto white balance mode and auto capture
color temperature. The range is 2400k~9400K
CDS：The IR LED: only activate when needed.
Illumination is 4 LUX±2LUX (LED on) / 8LUX± 2LUX(LED off)。
CDS SENSOR
LENS：Super sensitivity BOARD LENS for optimum low light pictures..
IR LED：Super power LED IR li ght，wavelength is 840nm for maximum
illumination.
LENS
IR LEDS
4
Mount：
Rotate the camera angle as required tighten thumbscrew.
Sunshade：
Adjust as necessary to prevent the sun from hitting the camera
lens, make sure that the sunshade is not in the camera’s field of
view.
Power and video connections：
Power: Regulated 12 Volts DC, center pin is positive (+)
Video: BNC, 1 Volt p-p
BNC Video Output
Scaffold
Sunshade
DC Power
5
INSTALLATION
1. Attach bracket to wall or ceiling.
2. Attach camera to bracket.
3. Aim camera and tighten mounting.
4. Attach a 75 ohm coaxial cable (95% copper shield recommended) to
the BNC output.
5. Apply regulated 12 Volts DC to the power connector.
6
SPECIFICATIONS
Model VL-10 VL-11
Pick Up Device 1/3” Interline transfer CCD
Resolution 420TV Lines
Lens 4.3mm
Total Pixels
Sync system 2：1 Internal Internal
Scanning s ystem
Video Output Composite 1.0 Vp- p / 75 ohms
Minimum Illum ination 0.5 lux color / 0 lux with IR on
IR Radiant Distance 65 feet 50 feet
S/N Ratio 50dB or more
Electronic Shutter Auto 1/6 0sec. to 1/100,000dec.
Horizontal Frequency 15.734KHz
Vertical Frequency 59.94Hz 60Hz
Backlight Compensation Built-in (Option
Power Supply Regulated 12V DC power supply
Consumption Current Max. 300mA Max. 280mA
Weight 0.46kg convert to
Dimensions 2.7” dia x 3.7” H 2.25” dia x 3.25” H
Operating Temp -14 to 122℉
Wall / Ceiling Mount
Included
Housing Silver / Aluminum
NTSC:537(H) x 505(V)
PAL:537(H) x 597(V)
525 line / 60 frames
Jumper ON / OFF )
required-model PSW-5
lbs.
7
Included
ON / OFF
switchable
0.505kg / 0.56kg
convert to lbs.
DIMENSIONS
VL-10
VL-11
8
Loading...