Speco Technologies HT65010XS, HT65010XW User Manual

 PRECAUTION

1. You can install the camera indoors or outdoors.

2. Choose an ideal location for the camera, since a camera unit must be protected against vibration.

3. Be careful not to scratch the lens or dome cover.

4. Use the camera within the temperature(-10 ~ +50 ).

5. Handle with care. Dropping it can cause serious dam-

age to the camera.

6. Avoid any direct sun light toward the lens.

7. Use the AC adaptor 12V DC regulated.(1A recom-

mendddded) (24V AC available-Dual power version only) of time.

◐FEATURES

1. IP67(Waterproof)

2. Durable MATERIAL : Body-Aluminum,

Dome : Polycarbonate

3. Wall & Ceiling mount available

4. New method to adjust the camera direction

 DIMENSION

 INSTALLATION

1-1. Ceiling mount installation

1-2. Mounting camera to electrical box

1-3. Pipe application

(1) Remove the bolt, the cable fixing screw and the

cable plug on the bottom of the base.

(2) Use the TEPLON tape to wipe the pipe.

1-4. Camera direction adjustment and fixing

(1) Cover can be installed four directions using two screws beside the cover.

(2) After loosening two screws on the cover, you can

adjust the direction of camera.

(3) You can tighten up two screws again to fix the direction.

2. Wall mount installation

3. Finishing installation

◐CONFIGURATION

◐HOW TO USE THE JOG LEVER

(1) MENU : To access the main setup menu. Push

this button for 1 second.

(2) TELE / UP : To close in on a far object.(ZOOM-IN)

/To move the arrow indicator to up.

(3) WIDE / DOWN : To widen the view.(ZOOM-OUT)

/ To move the arrow indicator to down.

(4) NEAR / LEFT : To see a near object clearly.

/ To move the arrow indicator to left.

(5) FAR / RIGHT : To see a far object clearly.

/ To move the arrow indicator to right.

(6) EXT. VIDEO : Plug your test monitor in here.

(The cable is option)

◐CAMERA FUNCTION SETTING

MAIN SETUP

OFF

CAMERA TITLE

Set Camera Title String and OSD Display Position.

ATW–MODE : OUTDOOR INDOOR

ATW is co ntrolled by color tem-perature range *MODE

- INDOOR : 3000~10,500°K

- OUTDOOR : level

AWC→SET

ONE PUSH

WHITE BAL

MANUAL

RED / BLUE Adjustable.

BACKLIGHT

OFF / LOW / MIDDLE / HIGH

Backlight compensatio n.

OFF

Motion detection off

MOTION DETECTION

AREA(4 Programmable zone/ SIZE) The words "MOTION DETECTED" appear on the screen and MD outpu t signal when movement is detected.

FOCUS

Refer to focus setup

EXPOSURE

Refer to exposure setup

SPECIAL

Refer to special setup

RESET

Returns to the level which was set by the manufacturer for shipment. (except for communication and Day & Night)

EXIT

Saves all settings, then exits.

FOCUS SETUP TABLE

AUTO

Focus is controlled automatically

MANUAL

Focus is controlled manually

MODE

ONE-PUSH

Focus is au tomatically adjust ed just once, after zoom positio n is changed.

OFF

Zoom tracking off

ZOOM TRK

Zoom tracking on

ZOOM SPEED

FAST / SLOW

Zoom speed Control

Digital zoom limit selectable (x2 ~ x10).

D-ZOOM

OFF

Digital zoom off

Zoom magnification set at power on (x1 ~ x10)

DIS ZOOM MAG

OFF

Zoom magnification display off

Zoom magnification display on.

ZOOM POS INIT

OFF

When initializ ed, zoom position is disabled.

LENS INIT

Execute lens initialization.

EXPOSURE SETUP TABLE

BRIGHTNESS

Brightness level adjustment.

MANUAL

IRIS is controlled manually.

IRIS

AUTO

IRIS is controlled automatically.

MANUAL

Shutter is controlled manually

SHUTTER

A. FLK

Anti-flicker

OFF

Automatic gain control off.

AGC

NORMAL / HIGH

Automatic gain control limit set.

OFF

Noise reduction off.

SSNR

LOW / MIDDLE / HIGH

Noise reduction level set.

OFF

Sense-up off

SENS-UP

AUTO

Sense-up limit selectable (x2 ~ x128)

SPECIAL SETUP TABLE

OFF

Turns function off

USER PRESET

Using the position preset function, 8 sets of camera shooting conditions can be stored and recalled.

OFF

Privacy mask off

PRIVACY

AREA(4 Programmab le zone) / SIZE / TONE adjustable.

COLOR

IR-Cut Filter is fixed to color position.

B/W

IR-Cut Filter is fixed to B/W position.

Day Night

AUTO 1, 2

When Inpu t lumina nce leve l is low, IR C ut Fil ter is s witched to the B/W po sition for increasing infrared sensitivity automa tically. And, it sw itches back to Color position when luminance is quite increased. Auto 1 mode is sw itched to IR Cut Filter mo re quickly than Auto

External Sync(can adjust desired phase from 0° ~ 359°). Trigger Signal: Auto Detection.

If the product is to be put out of operation definitively, take it to a local recycling plant for a disposal which

HT65010XS, HT65010XW

COMMUNICATION SETUP TABLE

OFF

ID not displayed

CAM ID

Camera names are displayed

OFF

Communication ID display off.

DISP CAM ID

Communication ID display on.

BAUD RATE

2400 ~ 57600

Baud-rate set (factory default : 2400).

UART MODE

8-E-1 / 8-0-1 / 8-N-1

Parity bits selectable. (factory default : 8-N-1)

DISABLE

Do not send a command back to the control & device.

RET PKT

ENABLE

Returning the data when com-munication.(Caution : Activate this function to use D&N.)

* Protocol: Pelco-D

IMAGE SETUP TABLE

OFF

Freeze image : OFF.

FREEZE

Freeze image : ON

OFF

Horizontal reverse : OFF

H-REV

Horizontal reverse : ON

OFF

Vertical reverse : OFF

V-REV

Vertical reverse : ON.

OFF

Sharpness control is disabled.

SHARPNESS

The Sharpness can be adjusted.

COLOR GAIN

The Color level can be adjusted (0~100)

◐SPECIFICATION

Model

HT65010XS, HT65010XW

Camera Type

100X Day & Night Auto Focus Zoom Dome Camera

Image Sensor

1/4" COLOR SONY SUPER HAD CCD

Effective Pixel

768(H) x 494(V)

TV Type

NTSC

Scanning System

2 : 1 Interlace

Sync. System

Internal / Line-Lock

Scan. Freq.(HORI)

INT: 15.734KHz L/L: 15.750KHz

Scan. Freq.(VERT)

INT: 59.94Hz L/L: 60.00Hz

Resolution

560 lines resolution

Video Output

1.0 Vp-p(Sync. Negative) with

75Ω Termination

S/N Ratio

More than 50dB(Weight on)

Min. Illumination

0.02 Lux(F1.8) / 50IRE

Gamma

γ = 0.45

Shutter Speed

Auto(x128 ~ 1/60 ~ 1/120,000sec) Sense-up and Sense-up limit is selectable, Flickerless

White Balance

ATW / AWC / Manual(1,800 ~ 10,500°K)

SSNR

LOW / MIDDLE / HIGH / OFF

Motion Detection

ON / OFF (4 programmable zone per screen)

Privacy Function

ON / OFF (32 zones, It consists of 8 group 4 programmable, zone per screen)

Flip

Vertical, Horizontal, Vertical-Horizontal, OFF

Preset

8 position

OSD

Yes

Zoom

Optical zoom 10X, Digital zoom 10X

Focal Length

f = 3.8 ~ 38(F 1.8)

Angle of View

51.2°(Wide End), 5.58°(Tele End)

Min. Working Distance

Communication

RS-485

Power Supply

24 Volts AC, 12 Volts DC - Dual Voltage

Current Consumption

Max. 500mA

Operating Temp.

-14 °F to 120 °F

Preservation Temp.

-4 °F to 140 °F

Dimension

Ø150 x 99.1(H)mm

Weight

1.9 Ibs.

※AII specification is subject to change without notice to

improve the quality

3B05754A

HT65010XS, HT65010XW