Speco SP30PTB Installation Instructions

sp30pt/b installsheet:Layout 1 12/16/08 12:50 PM Page 1

User Installation and Assembly Instructions

Hanging Pendant Speakers (SP30PT/SP30PTB)

• Ideal for installations where ceiling
or wall mounting is prohibitive

• Built-in 70/25V transformer

• Speaker includes hanging mount chain

Installation

A. Recommended wiring: 18 gauge copper wire (or heavier)

B. Note: Speaker wire alone is NOT sufficient for mounting.

A separate mounting wire, chain or cable (not included) MUST be used.

C. Use extreme care in mounting. Use a wire, chain or cable (not included) capable of supporting

at least 20 pounds of weight, and attach securely to overheard rafters or secure mount in ceiling.

D. Fasten end of wire, chain or cable securely to the top of the included tri-cable hanging mount chain.

E. Insert each of the three sections to the three built-in hooks on the speaker.

F. In installations where safety is an extreme concern or where required by local jurisdiction,

an additional safety loop has been installed to the top of the speaker.
It is recommended to use this loop in all installations.

G. Speco Technologies assumes no liability for improperly installed speakers.

H. Refer to below illustrations for assembly instructions

Attach end of mounting
cable through swivel
mount at top of
hanging mount chain

Hanging

Installation

Loops at end of each section
will slide right over hook on speaker.

SP30PT (White)
SP30PTB (Black)

Woofer 5.25" Polypropylene
Tweeter 1/2” Mylar
Frequency 95Hz-20kHz
SPL 92 +/- 2 dB
Wattage 30 Watt RMS/60 Watt Max
Impedance 8 Ohms
Transformer 70V/25V (30W/15W/ 7.5W/ 5W/2.5W)

Specifications