Speco OPTZWM User Manual

Installation

WALL MOUNT WALL MOUNT

Installation

CONTENTS

1. CEILING MOUNT BRACKET 1 EA

2. SET ANCHOR BOLT (W5/16) 4 EA

3. M3 x 6 SCREW 2 EA

4. L-WRENCH(3mm) 1 EA

5. MANUAL 1 EA

1. If you want to install the Camera on the concrete wall, you need to make

12.5mm diameter 4 holes by drill like FIG. 1. (Depth 37mm)

2. Install SET ANCHOR BOLT on the holes.

3. Fix the SET ANCHOR BOLT of the bracket by nut. (FIG. 2)

215.6

4-Ø12.5

136

FIG. 1 FIG. 2

[ The Cable Into the Ceiling ] [ The Cable Out of the Ceiling ]

4. Fit the Indoor Bracket into the groove of the Wall Mount Bracket as FIG. 3. Hang the Safety Wire 1 of the Indoor Bracket up in the Wall Mount Bracket and

tighten them up with Screw M4 x 8. (FIG. 4)

5. Hang the Safety Wire 2 of the Indoor Bracket up in the Camera as FIG. 6.

6. You can make wires simple by cable ties. Insert mount holder and twist the camera counterclockwise. (FIG. 6)

7. Place the Camera mount Holder on the Bracket Mount Hole. To insert them easily, keep 10°interval of Lock Holder 1 and Lock Holder 2.

8. Screw up Lock Holders with screws. (FIG. 7)

Mount Holder

Safety Wire 2

Cable Tie

FIG. 5

FIG. 6

Wall Mount

Bracket

Indoor Mount

Safety Wire 1

Screw M4 x 8 (4 EA)

Safety Wire 2

FIG. 3 FIG. 4

Lock Holder 1

Lock Holder 2

Safety Wire 1

M3 x 6 Screw

FIG. 7