Speco O2iB8M Quick Install Manual

QUICK INSTALL GUIDE

O2iB8M
2MP Intensifier(R) IP Bullet Camera

Please read this guide carefully before operating
the unit and retain it for future reference.

This lightning flash with arrowhead symbol within an equilateral triangle
is intended to alert the user to the presence of uninsulated dangerous

voltage wi thin the product’ s enclosure th at may be of sufficient
magnitude to constitute a risk of electric shock to persons.

The exclamation point within an e quilateral triangle is in tended to
alert the user to the presence of important operating and maintenance

(servicing) instructions in the literature accompanying the product.

WARNING: This product contains chemicals known to the State of California to cause cancer
and birth defects or other reproductive harm. Wash hands after handling.

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user could lose the authori

ty to operate

this equipment if an unauthorized change or modification is made.

REGULATORY INFORMATION: FCC Part 15

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.

• A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of
this product in the end user.

• Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.

• Holes in metal, through which insulated wires pass, shall have smooth well rounded
surfaces or shall be provided with brushings

.

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

• Extremely hot or cold places (operating
temperature 14 ℉ to 122 ℉, however, we

recommend that the unit be used within

a temperature range of 32 ℉ to 113 ℉ )

• Damp or dust place

• Places exposed to rain

• Places subject to strong vibration

• Close to generators of powerful

electromagnetic radiation such as radio
or TV transmitters.

• Do not use the camera in such place
where rapid temperature fluctuation by

switchin

g an air conditioner on and off.

Warning: Do not install this equipment in
a confi ned sp ace su ch as a bookcas e or

similar unit.

Note:

Plea se make sure the produc t is installed
appropriate plac es wher e secured fr om
flood, such as under the eaves, to operate

properly. This product is certified as IP66
standard. However, if there is any flood

concerns, it is highly recommended to use
an outdoor Hous

ing. When you install the

camera inside an outdoor Housing, please

use one of the following methods:

1. Remove the front glass of Housing
before installing the camera.

2.

To keep the front glass of Housing,

remove the front cover, and then put
the camera close to the front glass.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this a

pparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings.
Install in accordance with the
manufacturer’s instructions.

8. Do not install near any heat sources
such as radiators, heat registers, stoves,
or other apparatus (including amplifiers)
that produce heat.

9. Do not defeat the safety purpose of
the polarized or grounding-type plug.

A polarized plug has two blades with

one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or the
third prong are provided for your safety.
If the provided plug does not fit into

your outlet, consult an electrician for
replacement of the obsolete outlet.

10. Protect the power cord from being
walked on or pinched particularly

at plugs, convenience receptacles, and
the point where they exit from the apparatus.

Be careful not to spill water or other liquids in the
unit. Be cautious not to get combustible or

metallic material inside the body. If used with
foreign matter inside, the camera is liable to fail or to

g et ca use of f ire or elec tri c sho ck.

Avoi

d viewing a very bright object (such as
light fittings) during an extended period. Avoid
operating or storing the unit in the following
locations.

• Remove dust or dirt on the surface of the
lens with a blower.

• Use a soft and lint-free, dry cloth(such as

glass cleaner) to clean the body. If it is
very dirty, use a cloth dampened with a

small quantity of neutral detergent then

wipe dry.

• Avoid the use of volatile solvents such

as thinn

ers, alcohol, benzene and
insecticides.
They may damage the surface finish and/
or impair the operation of the camera.

•

This camera is designed for mounting

on the ceiling or wall. If you install this

camera upside down, it may cause
malfunction.

11. Only use attachments/accessories

specified by the manufacturer

.

12. Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or

sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus

combination to avoid injury from tip-over

.

Handling of the unit

Operating and storage
location

13. Unplug this apparatus during lightning
storms or when unused for long periods

of time

.

14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any

way, such as power-supply cord or plug

is damaged, liquid has been spilled
or objects have fallen into the apparatus,
the apparatus has been exposed to rain
or moisture, does not operate normally,
or has been dropped.

Important Safety
Instructions

Caution: Make sure the power supply voltage

is correct before using the camera.
Caution: Do not drop the camera or subject it
to physical shock.

Caution: While shipping, the camera should
be packed in its original packing.

Warning : Wirin g method s shall be in
accordance with the National Electric Code,

ANSI/NFPA 70.

Warning: To reduce a risk of fire or electric
shock, do not expose the internal apparatus

to rain or moisture

Warning: Install the camera on a ceiling or
wall where can withstand the weight of 5

time s of t he camera inc lud ing mou nting
bracket.

Cauti

on: The internal apparatus shall not be

exposed to water (dripping or splashing) and
no objects filled with liquids, such as vases,

shall be placed within the enclosure

Caution: The sensor may be burned out by a
laser beam, so when any laser equipment is

being used, make sure that the surface of the
sensor not be exposed to the laser beam.

Caution: This installation shall be made by a
qualified service person and shall conform to
all local codes.
Caution: To av oid electrical shock, do not
op

en the cabinet. Refer servicing to qualified

personnel only.

Warning: Please adopt the power adapter
which can meet the safety extra low voltage

(SELV) standard. And source with DC 12 V or
AC 24 V (depending on models) according
to the IEC60950-1 and Limited Power Source

standard.

Warning : This is a clas s A produ ct . In a
dom est ic environmen t this product may

cause radio interferenc e in which case the
user may be requi

red to take adequate measures.

To disconnect power from mains, pull
out the mains cord plug. When installing

the product, ensure that the plug is easily
accessible.

This guide includes instructions for installing and using this IP camera

Introduction

Features

• Multi-streams for live view and recording

• H.265/H.264/MJPEG compression algorithm

• Two-way audio communication

• True WDR operation

• Color in low light without IR LEDs

• Motorized zoom with auto focus

• Power sources: 12 VDC, PoE (Power over Ethernet)

• NTSC or PAL programmable video output

• IP66 compliant for weather resistance