Speco CLPR67B4B User Manual

ITEM

CLPR67B4B

IP Rating

IP66

Type

Monochrome

Signal System

NTSC/PAL

Pick Up Device

1/3" Sony High Resolution CCD

Picture Elements

NTSC: 811H×508V; PAL: 795H×596V

Resolution

550 TV Lines

LEDs

20 Super High Power LEDs

Vertical Frequency

NTSC: 60Hz; PAL: 50Hz

Horizontal Frequency

NTSC: 15.734KHz; PAL: 15.625KHz

Clock Frequency

NTSC: 28.636MHz; PAL: 28.375MHz

Scanning System

2:1 Interlace

S/N Ratio

≥50dB

Lens

10-40mm Varifocal Auto Iris IR Lens

Video Output

1V

p-p

,75Ω

Power Supply

DC12V ± 10%

Current Consumption

1300mA (Max)

Recommended IR Range

16.3ft – 98.3ft (5m – 30m)

Dimension

18.23” × 9.45” × 5.51” (463 × 240 × 140mm)

Weight

88.2oz (2500g)

Storage Temperature

-22～140°F (-30～60°C)

Operating Temperature

-22～104°F (-30～40°C)

License Plate Camera

CLPR67B4B

Included Accessories

1. User Manual x1

2. Screws x4

3. Anchors x4

4. Adaptor x1

5. Hex shape Wrench x2

6. DC Connector x1

7. Mounting template x1

Specifications

Installation Precautions

1. Avoid installing camera where there are frequent vibrations or shocks.

2. Please keep the glass in front of the camera clean. Do not touch it directly.
Use a soft cloth with alcohol to wipe glass if necessary.

3. The available IR range of this camera is shown in the specification.

Please be sure to place the camera within the specified range.

4. In order to prevent damage to the camera, please do not loosen any screws or
covers unless modifying settings.

5. Please do not operate camera beyond conditions listed in the specification.

Use 12V DC regulated power supply to avoid damaging camera.

We reserve the right to modify product design and specification without notice and without incurring any obligation

① Use the hex shape Wrench to loosen the two screws on the left side

of camera housing, then you can open the sun shield.

② Remove the foam covering the box camera, and move forward the

box camera into the hole of IR board.

③ Adjust the lens till the image is perfect, and then tighten the two

screws on the plastic plate.

④ Re-screw the sun-shield.

Changing IR Settings

If you want to change the IR settings, please remove the rear cover.
There are two Resistors with phillips head knobs, refer to the picture below.
Resistor A: Controls the intensity of the IR LEDs

Turning (Clockwise) will increase intensity
Turning (Counter-Clockwise) will decrease intensity

Resistor B: Controls the lux threshold needed for triggering the IR LEDs

Turning (Clockwise) will increase lux threshold
Turning (Counter-Clockwise) will decrease lux threshold

Refer to the diagram below for optimum viewing angle.

Lens Adjustment: