Speco CLPR66H User Manual

ITEM

CLPR66H

IP Rating

IP66

Type

Monochrome

Signal System

NTSC/PAL

Pick Up Device

1/3" 960H CCD

Picture Elements

NTSC:1020H×508V PAL:1020H×596V

Resolution

700 TVL

Min Illumination

0Lux (8Pieces super high power IR LED)

Vertical Frequency

NTSC:60Hz; PAL:50Hz

Horizontal Frequency

NTSC:15.734KHz; PAL:15.625KHz

Clock Frequency

NTSC/PAL:36MHz

Scanning System

2:1 Interlace

S/N Ratio

≥52dB

Lens

9-22mm Varifocal Auto iris IR Lens

White Balance

ATW

Back Light

OFF

Auto Gain Control

ON

Video Out-put

1V p-p,75Ω

Power Supply

DC12V ±10%

Current Consumption

380mA

IR Effect Distance

2~15m （6.56~49.18ft）(Outdoor)

Dimension

305×124×198mm (12.01”×4.88”×7.79”)

Weight

1750g (61.72oz)

Storage Temperature

-30～+60℃ (-22～+140℉)

Operating Temperature

-30～+40℃ (-22～+104℉)

License Plate Capture Camera

 ITEM №: CLPR66H

 Caution for Installation

1. Resistor A: If you want to change the intensity of the IR light, please open the
cover at the bottom of the camera(As showed in the following picture), you can
adjust the IR light intensity.

2. Resistor B: If you want to change the working time of IR Led, please open the
cover at the bottom of the camera(As showed in the following picture), you can

adjust the IR LED working time.” – “refers to the IR LED will start working under

the darker situation. “+” refers to the IR LED will start working under the brighter

situation.

 Packing

1. Camera X1

2. User Manual X1

3. Screw X4

4. Plastic-Conical-Anchor X4

5. Mounting drawing paper X1

6. Hexagonal Wrench X1

 Specification

Remark: Non-regulative adaptor may cause camera damaged.

 Caution for Installation

1. Please do not install the camera where the vibration always happens, or the
camera will be damaged.

2. Please keep the glass in front of the camera clean. Do not touch it directly. You
can use a soft cloth with alcohol to wipe if necessary.

3. The available IR range of this camera is shown in the specification. Please be

sure to place the camera in the working distance when it works.

4. In order to prevent short circuit, please do not loosen any screws in the

camera at random.

5. Please do not let the camera work in the conditions which is beyond the most

extreme and demanding of operating conditions and climates shown in the
specification. When any abnormalities happen, please turn off the camera and
contact your local dealer or us right away.

Pay attention to the setting angle. The picture in the right is for your reference.