Speco CLED30D1W, CLED30D7B, CLED30D7W User Manual

3B25

278A

CLED30D1B, CLED30D1W
CLED30D7B, CLED30D7W

◈NOTES:

1. Do not install the camera outdoors.

2. Choose a location for the camera which is free of moisture and vibration.

3. Be careful not to scratch the camera lens or dome cover.

4. Do not operate camera beyond listed temperature (14°F to 122°F).

5. Handle with care. Dropping it can cause serious damage to the camera.

6. Avoid any direct sun light toward the lens.

7. To avoid shorting or damaging the camera, use only power supplies which
meet the listed specifications (12VDC, min 500mA)

◈FEATURES

1. High Resolution (600 TV-Line).

2. This camera is flexible to install with its 3-axis camera construction, this
allows for the camera to be mounted to ceiling, wall or slope surfaces.

3. IR Range of up to 65’

◈HOW TO INSTALL

1. Opening the dome cover

Insert the handle to the side hole and twist it, then lift the dome cover. (Remove
the protection sheet after installation is completed)

3. Camera angle adjustment

a. Pan adjustment: Turn the disk of camera and then adjust direction to the right

or left (-180˚ to 180˚)

b. Tilt adjustment: Turn the camera holder (shown below) to adjust the direction

up or down (6˚ to 90˚)

c. Roll adjustment: Rotate the camera holder (-178˚ to 178˚)
<Caution> If the camera is adjusted beyond the angle limit, it may cause damage

to the camera.

◈DIMENSIONS

2. Camera installation

a. Mount the camera set with the supplied screws on ceiling or wall.
It is recommended to utilize the supplied screws.

b. Please refer to Section 3 for details on Camera angle adjustments.
c. Lens adjustment (Vari-focal Lens only)
For access to the focus knobs the IR cover must be separated.

①By turning the "Tele-Wide" knob, you can access a range of focal lengths

within specified limits.

②Once the focal length is determined turn the "Near-Far" knob, to set the

focus for the desired scene.

d. Re-assemble the camera.

◈SPECIFICATION

Model No.

Image Sensor 1/3" COLOR HIGH SENSITIVITY CCD

Effective Pixel 768(H) x 494(V) Pixel

Scanning System 2:1 Interlace

Sync. Type Internal

Resolution 600 TV-Line

S/N 48dB or More(AGC OFF)

Video Output

Min. Illumination

Gamma

White Balance AUTO

Shutter Speed 1/60 ~ 1/100,000sec.

AGC AUTO

Day & Night Electronic (Auto)

LED 25pcs, Dynamic IR 22pcs, Dynamic IR

Lens f = 3.6mm f = 2.8 ~ 12mm

Power Supply Regulated 12V DC ±10%

Current Consumption Max. 250mA (@12V DC)

Operation Temp. 14 °F to 122 °F

Preservation Temp. -4 °F to 140 °F

Dimension Ø111.9 x 87(H) mm

Weight 8 oz

AII specifications are subject to change without※ notice to improve the quality.

Speco Technologies is constantly developing product improvements.
We reserve the right to modify product design and specifications without notice and without
incurring any obligation.

CLED30D7B
CLED30D7W

1.0 Vp-p(Sync. Negative) Termination 75Ω

LED OFF : 0.1Lux(F/1.2)
LED ON : 0Lux (65’ Range – Indoor)

γ= 0.45 typ.

CLED30D1B
CLED30D1W

Rev. 08/17/12