Speck IPMDOCK Users Manual

IP-MDOCK

User’s Manual

一 、Hardware Configuration

SPECK

二 Instructions

1、 Power Source——Connect cigarette end to the car cigarette port. Revolve lock knob clockwise till

tight. Revolve lock knob anti-clockwise till loose and pull out cigarette.
2、 Turn on——Press the power key for 1 second. LCD display light on.
3、 Frequency adjust——knob revolve clockwise frequency up with step 0.1MH.revolve anti-clockwise

frequency down with setp 0.1MH.Hold knob for more than several seconds quick adjust frequency

with step 1MHz.

4、 Frequency memory——Adjust knob to a wanted frequency. Press and hold M1(M2 or M3) for

about 2 seconds.M1 show on LCD display. Then frequency memoried on M1 button.M1 disappear
after release memory button .Press M1 briefly get the wanted frequency memoried in M1 button
directly;

5、 Open connector cover，connect with IPOD MP3 Player（connector cover can push outside），Press

IPOD Player button，IPOD music transmit through transmitter.;

6、 FM radio tune to the same frequency as the transmitter to enjoy MP3 music.
7、 Press both left and right release button then draw out to pull out IPOD Player.
Note：Ipod Player pause play when pull out cigarette or car shutdown..

Warning: Changes or modifications to this unit not expressly approved by the party responsible for co mpliance
could void the user authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

this device may not ca use ha rm ful inte rfer ence, a nd (2) this device mu st ac ce pt a n y i nter ference rece i ved,

including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
 Consult the dealer or an experienced radio/TV technician for help.

Company Name: Speck Products
Company Address: 227 Fprest Avenue, Palo Alto, CA 94301, USA
Contact pweson: Bill Welch

Tel: [phone]

Fax: [phone]