Spear & Jackson ProjectAir TA-COMP10 Operating Manual

TA-COMP10

Direct Drive Compressor

Operating Manual

Index

Important Safety Instructions 2

Electrical Safety 2

Use of Extension Cords 2

General Safety Rules 3

Assembly & Operating Instructions 4-5

Automatic On/Off Switch 6

Overload Protection 6

Reset Procedure 6

Pressure Regulator 7

Pressure Gauges 7

Safety Valve 7

Shutting Down Your Compressor 8

Environmental Responsibilities 8

Maintenance 8

The Compressor & Its Components 9

Trouble Shooting 10

1

Important Safety Instructions

When using this product, basic safety precautions should always be followed, including –

DO NOT OPERATE A COMPRESSOR WHEN UNDER THE

INFLUENCE OF ALCOHOL OR DRUGS.

1) Read all instructions prior to using the product.

2) To reduce the risk of injury, close supervision is necessary when the compressor is in use near
children or infirm persons.

3) Know how to stop the compressor and be able to reduce the pressure immediately.

4) Be completely familiar with all the controls.

5) Do not wear loose clothing or jewelry as this could present a hazard.

6) Do not reach over machines with moving parts when in operation.

7) Maintain proper balance and footing at all times.

8) Do not use the compressor if the power cord shows any signs of damage or wear. Repair or replace
the damaged cord before use.

9) Do not yank on the cord to disconnect it from the power point.

10) Keep the cord away from heat sources, oil and sharp ridges.

11) NEVER move the unit by pulling on the air hose. Use the handle provided at the front and on the rear
of the tank.

12) Keep the work area clean and tidy.

13) Keep the work area well lit.

14) Keep the work area well ventilated.

Electrical Safety .

This product should only ever be connected to a properly manufactured, fitted and earthed power outlet.

Use of Extension Cords

Use of an extension cord with this product is NOT RECOMMENDED.

Warning !

To reduce the risk of electrocution, keep all connections dry and off the
ground. Do not touch the plug with wet hands.

2

General Safety Rules.

1) Always wear ear and eye protection when you use this product, or are in the vicinity of the
product when it is use.

2) Do not use the compressor in areas near combustible materials, combustible fumes or dust.

3) Always use a respirator or mask when spray painting or whenever there is a possibility vapors
may be inhaled. Read all instructions provided with the mask to ensure it provides adequate
protection against inhaling harmful vapors.

4) DO NOT ALLOW CHILDREN TO OPERATE THE COMPRESSOR AT ANY TIME.

5) DO NOT MAKE ANY MODIFICATIONS TO THE UNIT OR ANY OF ITS COMPONENTS.

6) UNITS WITH BROKEN OR MISSING PARTS OR WITHOUT THE PROTECTIVE
HOUSING OR COVERS SHOULD NEVER BE OPERATED.

7) Do not leave the compressor unattended while the pressure switch is in the “I” (On) position.

8) Do not add or change oil while the compressor is in operation.

9) Use only the supplied or recommended lubricating oil for the compressor

10) This compressor is fitted with an automatic “On/Off” switch. When the switch is in the “on” position,
the compressor may start operating at any time when the pressure in the tank falls below the preset
level of the pressure switch.

11) Disconnect all tools, fittings, etc and drain tank of remaining air if leaving unattended for prolonged
periods of time.

12) To reduce the risk of fire or explosion, never spray flammable liquids in a confined area.

13) Never directly inhale the compressed air produced by a compressor.

14) Do not use the air from the compressor for charging breathing/scuba tanks.

15) Do not use welding equipment in close proximity to the compressor. Do not weld anything to the air

tank of the compressor: this could dangerously weaken the tank and will void the warranty.

16) To avoid the risk of burns and injury from moving parts, do not operate the compressor with the
safety shield removed. Allow hot parts to cool before handling or servicing.

17) Before transporting the compressor make sure that the pressurised air is bled from the tank and that

the compressor is firmly secured.

18) Protect the air hose and cord set from damage. Inspect for weak or worn spots regularly and replace if

necessary.

19) Never apply the outlet air of this compressor directly on to any part of a person’s body. Do not
attempt to block the air outlet with your finger or any part of your body.

20) The tool must be used only for its prescribed purpose. Any use other than those mentioned in this

Manual will be considered a case of misuse. The user and not the manufacturer shall be liable for any
damage or injury resulting from such cases of misuse.

21) The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting
from such changes.

Warning !

In the event that an air line is cut or broken, the air supply must be turned
off at the compressor.

3