Page 1
OWNER’S MANUAL
OG Series
Outdoor Landscape Speakers
OG Three
Page 2
INTRODUCTION
Congratulations on your purchase of the OG Series of outdoor speakers. The OG Series speakers have been designed to provide
excellent performance in all types of outdoor environments. To be sure that you optimize the performance of your OG Series
speakers, please read this manual carefully.
CAUTION
Although they are designed to withstand the elements, there are precautions you should take to optimize the long-term performance of your speakers. Keep soil and wood chips from covering the speaker grille. If soil accumulates on the grille, it can be
rinsed away with low water pressure. Chemicals commonly used in the yard can potentially damage parts of the speaker. Avoid
spraying such chemicals onto or near the speaker. Also avoid placing the speakers where the grille area will come in direct contact with spray from sprinklers.
SPEAKER PLACEMENT
• If you desire music over a wide area, it is best to have a larger number of speakers playing at low volume, rather than a few
speakers playing at high volume. Keep this in mind when designing your outdoor system.
• Ideally, you should place the speakers as close to the primary listening area as possible. The perceived volume of the speaker
decreases rapidly as it is moved further from the listener.
• Direct burial wire or conduit for new yard construction must be run to the location of the speakers. Keep in mind that patios,
walls and other features in your yard may be difficult to get around when wiring.
SPEAKER INSTALLATION
• Each OG Series has a two-conductor 16 AWG speaker wire exiting the bottom. This wire should be connected to a similar wire
run that comes from your audio system.
• When attaching the wire to the OG Series speaker, it is critical that a high quality connection is achieved. A poor connection
may lead to corrosion and a decline in or loss of performance. For best results, use the set of weatherproof wirenuts included
with the speaker. Another option is to use a watertight direct burial box or crimp or solder the wires together and use a heat
shrink tube to seal each connector.
• There are through holes on both the stake and speaker enclosure in case you choose to attach an anti-theft security harness.
See Figure 1 and 5.
• The words "Speaker Faces This Way" are printed on the stake. This will tell you which direction your speaker will be facing when
attached to the stake. See Figure 1.
Follow steps 1-4 and see Figure1-6 for detailed illustrations of the installation process.
1. Insert the stake into the ground by hand. See Figure 1. NOTE: To avoid damaging or braking the stake, DO NOT use a metal
hammer or any hard object. If the soil is too hard to put in by hand, use your foot to continue inserting the stake into the ground.
See Figure 2.
2. Attach the speaker wire to the wire run coming from your audio system (observing the proper polarity with your amplier: + to +
and - to -.
3. Attach the OG series speaker to the stake using the security knob. Turn the security knob clock wise, but do not tighten it
completely. See Figure 3 and 4.
4. Tilt the OG series speaker to the desired angle then continue turning the security knob until it is fully tightened. See Figure 5
and 6.
1
Page 3
Speake r Faces
This Way
FIGURE 1
FIGURE 3
Secur ity har ness through holes
FIGURE 2
FIGURE 4
FIGURE 5
Secur ity har ness through hole
FIGURE 6
2
Page 4
SPECIFICATIONS
Speaker Type:
OG Three
Outdoor Landscape
Dimensions:
7
⁄8" (176mm)
6
Speaker
Tweeter:
Woofer:
N/A
Sealed 3" Aluminum Cone
Full-Range Driver
Impedance:
Sensitivity:
Frequency Response:
Power Recommendation:
8 ohms
88dB 1W/1m
110Hz - 20kHz
20 watts
9
3
⁄16" (90mm)
6 5⁄16" (160mm)
In our attempt to constantly improve our products, features and specications are subject to change without notice.
LIMITED LIFETIME WARRANTY
3
⁄4" (95mm)
3
SpeakerCraft Inc. warrants to the original retail purchaser only that this SpeakerCraft product will be free from defects in materials and workmanship, provided the
speaker was purchased from a SpeakerCraft Authorized Dealer.
Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were purchased,
or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is preferable to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the risk or loss or damage in transit is to be borne by the purchaser. If
upon examination at the Factory or SpeakerCraft Authorized Dealer it is determined that the unit was defective in materials or workmanship at any time during
this warranty period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair or replace this product at no additional charge, except as set
forth below. If this model is no longer available and can not be repaired effectively, SpeakerCraft, at its sole option may replace the unit with a current model of
equal or greater value. In some cases where a new model is substituted, a modification to the mounting surface may be required. If mounting surface modification is required, SpeakerCraft assumes no responsibility or liability for such modification. All replaced parts and product become the property of SpeakerCraft Inc.
Products replaced or repaired under this warranty will be returned to the original retail purchaser, within a reasonable time, freight prepaid.
This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the product which has not been authorized
or approved by SpeakerCraft. This warranty also excludes normal cosmetic deterioration caused by environmental conditions. This warranty will be void if the Serial
number on the product has been removed, tampered with or defaced.
This warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted above, the
purchaser’s sole remedy shall be repair or replacement as provided above. In no event will SpeakerCraft be liable for any incidental or
consequential damages arising out of the use or inability to use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized
Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion
or limitation of consequential damages, so the above limitation and exclusion may not apply.
All implied warranties on the product are limited to the duration of this expressed warranty. Some states do not allow limitation on the
length of an implied Warranty. If the original retail purchaser resides in such a state, this limitation does not apply.
SpeakerCraft offers a variety of accessories to make your installation of this and other SpeakerCraft products easy, economical,
Declaration of Conformity
and professional. Contact your authorized SpeakerCraft Dealer for more information. For technical inquires, please call 1-800-4480976 or e-mail us at techsupport@speakercraft.com. We are available to assist you every weekday, except holidays, between the
hours of 7:00 a.m. and 5:00 p.m. PST.
We, Speakercraft Inc.
940 Columbia Ave.
Riverside, CA 92507
USA
declare under our sole responsibility that the products described in this owners manual are in compliance with technical standards
EN 50081-2 EMC, Emis-
sion
EN 50082-2 EMC,
Immunity
SpeakerCraft Inc.
940 Columbia Ave. Riverside CA 92507
(800) 448-0976 Fax (951) 787-8747
940 Columbia Avenue, Riverside, CA 92507 | USA (800) 448 0976 Fax (951) 787 8747 International +1 951 787 0543 | www.speakercraft.com
LIT761301
Loading...