
CIMARRON CL1 MAF INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
OR
MAINTENANCE
CIMARRON
FIXTURE
LE
D
MAST
AR
F
LATWAS
1
. MOUNTING
Remove Arm Cover by removing the (4) Screws.
Attach Fixture to
approx. 42 Ft-Lbs.
Engage (4) 3/8-16 X ¾” Set-screws to the cast
Slip Arm Fitter onto
After Leveling the Fixture attached to the
13/32” dia.
Remove Arm Fitter
through Mast Arm Fitter and into the Fixture Arm.
Slip
(4) Set-screws
S
ecure 4” Bolt
approx. 20 Ft-Lbs.
hole through the
Mast
Arm Fitter
HER
, LO
CKWASHER, NUT
M
AST ARM PIPE
3/
AFTER
LEV
IS ATTA
U
SE HOL
F
IEL
MAST ARM
Mast Arm Fitter
Mast
Arm and adjust Fixture orientation whil
Mast
and Fixture
with Fixture
to approx 18 Ft-Lbs.
with Flatwasher, Lockwasher, and Nut (Hardware Included). Torque the Bolt and Nut to
ELING
CHED
TO MAS
E I
D DR
N MAST A
ILL HOL
FITTER
Pipe Arm.
from Mast Arm
TO FIXTURE ARM AND TO MAST ARM PIPE
with (2) ½” Hex Bolts,
Mast
back onto the Mast Arm
M FITT
8"
FIXTUR
E T
Mast Arm
Arm, use hole
ER
SET-SCREWS
E THAT
T ARM PIPE,
RM F
HROUGH
Pipe
and Pull the supply wires from Mast Arm Pipe
FIXTURE
ARM
ITTER TO
PIPE.
Lockwashers
Fitter.
s on each side of Mast Arm
Pipe
and Flatwashers. Torque bolts to
e tightening the (4) Set-screws
, Install the 4” l
4"
ong Bolt
1/2" HEX BOL
LO
FLAT WAS
SCRE
LON
G BOL
.
Fitter to Field Drill
and tighten the
CKWASHER
T
HER
AR
M C
W
T
OVE
R
WARNING:
A
See Installation Instructions for Cimarron LED
9303760
701 Mill
FAILURE TO INSTALL THE LONG BOLT COULD POSSIBLY ALLOW THE FI
ROTATE OR DISENGAGE FROM THE PIPE ARM.
POWER MUST BE OFF.
(WIRING MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN)
Wire service leads to fixture power leads according to local and National Electric Codes.
Luminaire
n optio
Wire connections to be made inside Arm with Fix
For direct wire connections, connect ground wire to green
white to
is equipped with universal voltage drivers capab
nal 347/480 V input transformer is available.
neutral then push connections back inside
2 REV B
ennium
Boul
eva
rd
Greenville, SC 29607
ture Wires and Supply Wires (by others).
Arm and attach Arm Cover.
, P/N
93034033
(864) 678-
MAST
AR
le of 120V-277V input
wire, connect black to black and
.
1000
.
XTURE TO
M FITT
ER
SUPPLY WIR
FIXTURE WIR
FIGURE 2
ARM
C
OVE
www.
spau
ARM
ES
ES
R
REM
OVE
lding-ltg.com
D