SparkLAN Communications WUBR125GN Integration Manual

802.11 WLAN Module Series

WUBR-125GN

802.11b/g/n USB Module
Ralink RT2770+2720,1T2R

FEA TURES & BENEFITS

 High-speed Wireless-N (draft 802.11n)
 802.11b/g compliant
 Supports USB 2.0/1.1 interface
 WPA/WPA2 (IEEE 802.11i), WEP

64/128 Support

Support Windows Vista/XP/2000,

Linux driver

SPECIFICATION

Chipset - RT2700U

Mac/BB Processor
RF Chip Ralink RT2720

Host Interface
USB type A or 4-pin Pin Header

LEDs

Link/Activity
Radio
Antenna

Operating
Frequency

Transmit Power

Receive Sensitivity

Power
consumption

Environmental

Temperature Humidity
Operating 0 ~ 55°C 10% to 85% Non-Condensing
Storage -20 ~ 65°C 5% to 90% Non-Condensing
Operating Voltage

Physical Specification

Dimensions

Ralink RT2770

2

x I-PEX(UFL) connector

 2.412~ 2.4835GHz ISM Band
802.11b: 1

802.11g: 1
802.11n: 15± 1dBm

802.11g : -70dBm @54Mbps

802.11b : -83dBm @11Mbps

802.11n: -83dBm @11Mbps

 802.11b@11Mbps Continue TX:450mA
 802.11g@54Mbps Continue TX :390mA

DC 5V ± 5%

60x25 mm

8± 1dBm
6± 1dBm

Weight 30g
Software

Driver

Security

 Windows 2000/XP/Vista
 Linux

 64/128-Bit WEP Key,
 WPA(TKIP with IEEE802.1x)
 WPA2(AES with 802.1x)

SparkLAN Communications Inc., All Rights Reserved. This document is for planning purposes only, and is not intended to
modify or supplement any specifications or warranties relating to products of SparkLAN Communications. SparkLAN may
make changes to specifications and descriptions at any time without prior notice.

www.sparklan.com / [e-mail] / [phone]

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:

z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
z Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with mini mum di stance 20cm between the radiator & your body.