SparkLAN Communications WPEQ450AC Users Manual

Wireless Module

Standards

IEEE 802.11ac/a/n (4T4R)

Chipset

Qualcomm Atheros 9984

Data Rate

802.11a: 54Mbps / 802.11n: MCS0~15/ 802.11ac: MCS0~9

Operating Frequency

IEEE 802.11 ac/a/n ISM Band, 5.180MHz~5.825MHz
*Subject to local regulations

Interface

PCIe

Form Factor

Mini PCIe

Antenna

4xIPEX connectors

Modulation

WiFi : 802.11ac: OFDM (BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM)

Power Consumption(Max.)

TX: 2250mA

RX: 750mA

Operating Voltage

DC 3.3V

Operating Temperature Range

-20°C ~ +70°C

Storage Temperature Range

-20°C ~ +90°C

Humidity

(Non-Condensing)

5%~90% (Operating)

5%~90% (Storing)

Dimension (in mm)

50.08mm x 29.85mm x7.8 mm (±0.5mm)

Weight (g)

≦ 10g

Driver Support

Linux (Open Source),

Security

WEP, WPA, WPA2, 802.1x

WPEQ-450AC

5GHZ MU-MIMO 4×4 802.11AC Mini PCIe Module

Wireless Module

OUTPUT POWER & SENSITIVITY

802.11a

Data Rate

Tx ± 2dBm

Rx Sensitivity

54Mbps

17dBm

≦-72dBm

802.11n / 5GHz

HT20

Data Rate

Tx ± 2dBm (1TX)

Rx Sensitivity

MCS7

19dBm

≦-68dBm

HT40

MCS7

19dBm

≦-66dBm

802.11ac

VHT80

Data Rate

Tx ± 2dBm (1TX)

Rx Sensitivity

MCS9

18dBm

≦-56dBm

VHT80+80

MCS9

14dBm

≦-56dBm

Wireless Module

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.

Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.

FOR MOBILE DEVICE USAGE (>20cm/low power)

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.

This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01
guidance, the following conditions must be strictly followed when using this certified module: