Spa Electrics LV50-12 Installation Manual

INSTALLATION GUIDE

FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS

ph: [phone]
[e-mail]
www.spaelectrics.com.au

INSTALLATION

5mm

93mm

500mm (MIN)

GROUND

LV50-12

LOW VOLTAGE TRANSFORMER

Mount unit using the 2 keyhole slots
provided, at 93mm centres.

CABLE TERMINATION

Spa Electrics recommends the use of an Electrical
Contractor or Pool Technician for connection of the Pool
Light to the Transformer.

1. Remove the terminal screw and clamp plate
from the terminal bolt.

The LV50-12 transformer has 2 outputs, each
with a pair of terminals. Each cable core should
be terminated as follows:

For the second cable core, repeat these steps
on the adjacent terminal.

Optional: Once the cable termination is complete,
anchor the cable to the transformer using the cable
management hooks provided. This will help protect the
cable from strain.

2. Place one of the stripped end of the cable on
top of the terminal bolt. Place the clamp plate
on top of the cable end and fasten the
connection in place. As the Transformer
outputs AC power the cable orientation is not
important

Ensure that the unit is installed at least

3.5 metres away from the pool and/or
spa and at a minimum of 500mm above
ground level.

INSTALLATION GUIDE

TRANSFORMER RATING

Input: 230-240VAC ~ 50Hz
Output: 2 X 25W 12VAC ~ 50Hz switched
Fuse: 2 x 3A 12VAC Blade Fuse
Auxilary GPO: 230-240VAC ~ 50hz 10amp Max Total
IP Rating: IP23

TECHNICAL SPECIFICATION

FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS

ph: [phone]
[e-mail]

www.spaelectrics.com.au

20180226

LV50-12

LOW VOLTAGE TRANSFORMER

CHECKING THE FUSE

The LV50-12 transformer includes 2 x 3amp
blade fuses, one for each output. The fuse is
designed to protect the transformer and light
cable from shorts & over loading, which may
lead to the premature replacement of the
transformer.

The following steps show how to check if your
transformer fuse has blown:

1. Remove the fuse cover.

2. Remove the fuse, the fuse may be held firmly
in the fuse holder, if so it may be necessary to
use a pair of needle nose pliers to gently
remove the fuse.

3. Check the center of the fuse for breaks. If the
fuse has blown, first check all cable
connections for shorts before replacing the
fuse.

Note: Spa Electrics uses generic blade fuses,
which can be purchased from any quality auto
parts/Electrical retailer.

CONDITION PROBABLE CAUSE REMEDY

GOOD BAD

No Output Power No Input Power Check input power GPO using another appliance.

If power is available at GPO, contact Spa Electrics
for further assistance

Blown Fuse Check fuse,

If the fuse has blown, first check all cable connections
for shorts before replacing the fuse.

If fuse wire is intact, contact Spa Electrics for further assistance.

TROUBLE SHOOTING