Contents
INSTALLING THE DEVICE 2
Headset Plug Notes 3
GETTING TO KNOW THE DEVICE 4
Idle Mode 5
Skype Tabs 5
Info Mode 5
Options Menu 6
USING THE DEVICE 8
Making Calls 8
Adjusting Ring Volume 8
Adjusting Voice Volume 8
Changing Ringtones 9
Double Ringing 9
Solving Echo Problems 9
BEFORE YOU
BEGIN
Computer Requirements
Windows XP
CD-ROM Drive
Skype Software
SOYO U201 USB PHONE USER MANUAL
Installing the Device
Before you can use the SOYO U201 USB Phone, connect the device to the
computer and install the software included on the CD.
1 Start up the computer.
2 Attach the USB cable connector of the U201 to an available USB port
on your computer. This USB port can usually be found on the back of
the computer case.
3 Insert the Installation CD into the CD-ROM Drive.
PACKAGE
CONTENTS
U201 USB Phone
Installation CD
4 Locate the installation file on the CD and double-click on it to install the
U201 software. The InstallShield Wizard will guide you through the
installation process.
5 Click on the Finish button after the installation is ov er.
6 (make sure that the Skype software is running before proceeding) Run
the USB phone software by clicking on the “
SOYO USB Phone”
icon in the Windows Start Menu.
When Skype alerts you that the SOYO USB Phone software is trying to use it,
choose the “Allow this program to use Skype” option and click on the OK but ton.
2
SOYO U201 USB PHONE USER MANUAL
The USB Phone Status icon will appear in the System Tray, located on the bottom
right corner of the screen. If you hover the mouse pointer over the icon, you should
be able to see the following:
The “Disconnected” message appears when the USB Phone fails to connect to
Skype, or an Internet connection is not available. Check Skype’s status and your
Internet connection to make sure they are online.
“Connected” means the USB Phone is set up correctly and is goo d to go.
Headset Plug Notes
A headset unit consisting of a pair of earphones and a microphone can be plugged
into the USB Phone’s Stereo Headset Jack. The jack is a 2.5mm one, and the
headset unit’s plug should have three stripes, as shown in the following image.
3
Loading...