Soyal AR-661UG, AR-661UG V2 User Manual

- 1 -

V150819

AR-661UG (V2) User Manual

Stationary UHF RFID Reader

Overview

As a long-range stationary radio frequency identification (RFID) reader, the AR-661UG(V2) is
around 920MHz-925MHz (Precise UHF band is able to adjust and comply with different countries’
standard by order) UHF RFID reader operable at various operating bands specified by individual
countries. It also complies with all standard protocols defined in ISO18000-6C.

Points for attention
The reader should be positioned so that personnel in the area for prolonged periods may
safely remain at least 20 cm (8 in) in an uncontrolled environment from the reader’s surface.

Federal Communications Commission (FCC) Statement

15.21

You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that may cause
undesired operation of the device.

RF exposure:
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not
be co-located or operating in conjunction with any other antenna or transmitter.

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.

- 2 -

V150819

AR-661UG (V2) User Manual

Stationary UHF RFID Reader

1 2 3 4 5

UHF Reader*1

L-Bracket*1

U-Bracket*1

Fixed Bracket*1

M6 screw*4

(Pore size: 2 Inches)

Contents

Dimensions

Output Cable Descriptions