Soyal AR-0400WF, AR-0400WS Installation Instructions Manual

INSTALLATION OF WATERPROOF ELECTROMAGNETIC LOCK FOR IN SWING DOOR.

Installation steps of waterproof electromagnetic

lock on in swing door.

1. ** Mounting bracket **

Locate the desired position on the doorframe and attach the mounting bracket
to this location using the 6 screws included in the package.

2. ** Electromagnetic lock **
Insert the 2 included screws through the pre-drilled holes on the lock and

screw tightly to the mounting bracket.

3. ** Z bracket **
Locate the proper position on the door that, when closed, will align

correctly with the electromagnetic lock on the doorframe. Drill 5
holes at this location and attach the Z bracket to it. One important
remark on tightening the Z bracket is that the tightening screw must
be accompanied by a spring-washer to avoid slippery.

4. ** Magnetic plate **

Insert the 2 PINs to the magnetic plate, place a pair of washers
separated by a rubber washer in between the magnetic plate and the

Z bracket, insert the M5 flat-head screw through the center of the

magnetic plate, pass through the washers and then tighten it to the

Z bracket. Do not install the magnetic plate to the Z bracket too
tight. Leave some space to allow for best performance between
the plate and the lock.

MODEL AR-0400WF

1. ** MOUNTING BRACKET **
FIRST, LOOSELY ATTACH THE MOUNTING BRACKET TO THE DOORFRAME BY
INSERTING 2 SCREWS THROUGH THE 2 PRE-DRILLED HOLES ON BOTH ENDS

OF THE MOUNTING BRACKET.

ADJUST THE MOUNTING BRACKET TO THE DESIRED POSITION AND THEN

TIGHTEN THE BRACKET TO THE DOORFRAME WITH ANOTHER 6 SCREWS.

2. ** ELECTROMAGNETIC LOCK **
INSERT THE 2 INCLUDED SCREWS THROUGH THE PRE-DRILLED HOLES ON

THE LOCK AND SCREW TIGHTLY TO THE MOUNTING BRACKET.

3. ** MAGNETIC PLATE **

FIRST, LOCATE THE PROPER POSITION ON THE DOOR THAT CORRESPONDS

TO THE POSITION OF THE ELECTROMAGNETIC LOCK WHEN CLOSED.
INSERT THE 2 PINS TO THE MAGNETIC PLATE AND DRILL 2 HOLES
(ABOUT 6-7 MM) ON THE DOOR AT THEPROPER LOCATIONS TO

ACCOMMODATE THE 2 PINS. DRILL A HOLE AT THE CENTER OF THE

PLATE ALL THE WAY THROUGH THE ENTIRE DOOR. INSERT THE M5

FLAT-HEAD SCREW THROUGH THE CENTER OF THE MAGNETIC PLATE,

THROUGH THE DOOR, THE WASHERS, THE ALUMINUM TUB AND THE BOLT.

DO NOT INSTALL THE MAGNETICPLATE TO THE Z BRACKET TOO TIGHT
. LEAVE SOME SPACE TO ALLOW FOR BESTPERFORMANCE BETWEEN THE

PLATE AND THE LOCK.

MODEL AR-0400WS