Sovereign Tracking Systems SOV333B User Manual

A/B unit Installation and Operational Instructions

Shown

Tracking Systems L.L.C.

PalTrack

ATS3-A/B

Operational Manual

®

ATS3 -

PalTrack

ATS3- A/B

Transmitter

Asset Tracking System
III (A/B)

Activation

The ATS3 designed by Sovereign Tracking
System LLC. provides a very affordable
and accurate tracking system for locating
and position asset and product within
localized facilities. The attachment of the
ATS3 unit to an asset or product is
performed in the following steps:

ATS3 -B

1. Open the packaging and remove the ATS3 transmitter.

2. Attach the ATS3 to an asset or product by orienting the transmitter assembly to the
asset or product so that the adhesive side of the transmitter is facing towards object.

3. Remove the protective adhesive paper from the ATS3 transmitter.

4. Orient the ATS3 to the desired location on the asset or product, and press the ATS3
FIRMLY to the asset or product.

5. DO NOT TRY TO RELOCATE OR REMOVE THE ATS3 FROM THE
ATTACHED ITEM.

6. IF THE ATS3 IS REMOVED FROM THE Asset, it will be set to alarm mode.

Adhesive

Sovereign Tracking Systems L.L.C. 1108 Industrial Pkwy, Brick New Jersey 08724

7. Once the ATS3 is secured to and asset or product, verify operation of the system by
moving the ATS3 transmitter either up or down, or side to side, and verify the data on
the computer. For details on computer operation, reference PalTrack installation
manual.

[phone] FAX [phone]

URL http://www.sovtechcorp.com

®

Tracking Systems L.L.C.

ATS3- A Configuration:

The ATS3-A is the base configuration transmitter with out data input capability. This configuration provides normal
operation under motion and emergency transmit notification when the transmitter is removed form an asset or object once
affixed and activated.

ATS3- B Configuration:

The ATS3-B provides a configuration whereby external data input can be detected from an asset or object. This data input
feature allows for a transistor to transistor (TTL) logic input e.g. “0” or “1”. The logic input voltage is either zero “0” Vdc for

logic “0” or a maximum of 5.5Vdc for a logic “1”. The status of this logic is transmitter as a status bi t during normal or
emergence transmit modes.

The data input in accomplished through the use of a “Mini Phone” plug. The outer shell of the mini phone plug is ground
with the center tip at a positive potential of no more than 5.5Vdc. For details on computer operation, reference PalTrack
installation manual.

Notice: The changes or modifications not expressly by the party responsible for compliance
could void the user’s

authority to operate the equipment.

Model: ATS3- (A/B)
FCC ID: N8TSOV333B
THIS DEVICE COMPLIES WITH PART I5 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE A ND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
MADE IN TAIWAN

Sovereign Tracking Systems L.L.C. 1108 Industrial Pkwy, Brick New Jersey 08724

[phone] FAX [phone]

URL http://www.sovtechcorp.com