Southwestern bell FA970 Owner Manual

1

Southwestern Bell

Freedom Phone®

All-Digital Telephone

Answering System

with Voice Day/Time

Stamp

FA970 OWNER'S MANUAL

TOLL FREE HELP LINE

1-800-366-0937

http://www.swbfreedomphone.com/

2

LOCATION OF CONTROLS
TOP VIEW 1. Battery Low LED Indicator

2. Answer On/Off Button

3. Time Set / Repeat Button

4. Mailbox 2 Play/Skip Button

5. Mailbox 2 Message LED

6. Mailbox 1 Play/Skip Button

7. Mailbox 1 Message LED

8. Microphone

9. Greeting Button

10. Stop / Save Button

SIDE VIEW

11. Rotary Volume Control

REAR VIEW

12. Ring Select 2/4/TS

13. Telephone Line

14. AC Adaptor Jack

15. Telephone Extension Line

3

PLEASE READ IMPORTANT SAFETY

INSTRUCTIONS ON PAGES 2-4 BEFORE USE.

Congratulations!

You have purchased an FA970 Digital Answering System with Voice Day/Time
Stamp manufactured to the highest standards of SOUTHEWSTERN BELL
FREEDOM PHONE® RETAIL SALES.

Digital Technology
This digital design utilizes a computer chip to perform answering system functions

more efficiently and with more versatile features than microcassette answering
machines.

BEFORE INSTALLING AND OPERATING THIS ANSWERING
SYSTEM, IT IS VERY IMPORTANT THAT YOU READ THIS OWNER’S
MANUAL.

IMPORTANT SAFETY INSTRUCTIONS

BEFORE USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS,
INCLUDINGTHE FOLLOWING:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the wall telephone jack and power outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for
cleaning.

4. Do not use this product near water, for example, near a bath tub, wash bowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

4

5. Do not place this product on an unstable cart, stand, or table. The product may
fall, causing serious damage to the product.

6. Slots or openings in the cabinet and the back and bottom are provided for
ventilation, to protect it from overheating. These openings must not be blocked or
covered. The openings should never be blocked by placing the product on a bed, or
other similar surface. This product should never be placed near or over a radiator or
heat register.

7. This product should be operated only from the type of power source indicated on
the marking label. If you are not sure of the type of power supply to your home,
consult your dealer or local power company.

8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it. Do not attach the power cord
to building surfaces.

9. Do not overload wall outlets and extension cords as this can result in the risk of
fire or electric shock.

10. Never push objects of any kind into this product through cabinet slots as
they may touch dangerous voltage points or short out parts that could result in the
risk of fire or electric shock. Never spill liquid of any kind on the product.

11. To reduce the risk of electric shock, do not disassemble this product, but
take it to a qualified serviceman when some service or repair work is required.
Opening or removing covers may expose you to dangerous voltages or other risks.
Incorrect reassembly can cause electric shock when the appliance is
subsequently used.

12. Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:

a. When the power supply cord or plug is damaged or frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed to rain or water.

5

d. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating instructions
because improper adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to restore the product to
normal operation.

e. If the product has been dropped or cabinet has been damaged.
f. If the product exhibits a distinct change in performance.

13. Avoid using a telephone (other than a cordless type) during an electrical storm.
There may be a remote risk of electric shock from lightning.

14. Do not use the telephone to report a gas leak in the vicinity of the leak.

Save These Instructions

SAFETY INSTRUCTIONS FOR BATTERIES

CAUTION
TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS,
READ AND FOLLOW THESE INSTRUCTIONS.

1. Use only the 1604A size alkaline batteries mentioned in the Owner’s Manual.

2. Do not dispose of the batteries in a fire. The cells may explode. Check with local
codes for possible special disposal instructions.

3. Do not open or mutilate the batteries. Released electrolyte is corrosive and
may cause damage to the eyes or skin. It may be toxic if swallowed.

4. Exercise care in handling batteries in order not to short the batteries with
conduction materials such as rings, bracelets, and keys. The batteries or
conductors may overheat and cause burns.

5. Do not attempt to recharge the batteries identified for use with this product.
The batteries may leak corrosive electrolyte or explode.

6. Do not attempt to rejuvenate the batteries identified for use with this product by
heating it. Sudden release of the battery electrolyte may occur causing burns or
irritation to eyes or skin.

6

7. When replacing batteries, all batteries should be replaced at the same
time. Mixing fresh and discharged batteries could increase internal cell pressure
and rupture the discharged batteries.

8. When inserting batteries into this product, the proper polarity or direction must
be observed. Reverse insertion of the batteries can cause charging, and that may
result in leakage or explosion.

9. Remove the batteries from this product if the product will not be used for a long
period of time (several months or more) since during this time the batteries could leak
in the product.

10. Discard “dead” batteries as soon as possible since “dead” batteries are more
likely to leak in a product.

11. Do not store this product, or the batteries identified for use with this product, in
high-temperature areas. Batteries that are stored in a freezer or refrigerator for the
purpose of extending shelf life should be protected from condensation during
storage and defrosting. Batteries should be stabilized at room temperature prior to
use after cold storage.

Save These Instructions

GENERAL INFORMATION BOX CONTENTS
This package contains:

• FA970 Digital Telephone Answering System

• One (1) AC Adaptor 120V AC

• Owner’s Manual

• One (1) Quick Installation Guide

• One (1) Remote Access Card

• Warranty Card (Part of Owner’s Manual) If anything is missing or damaged, contact
the place of purchase, Keep the shipping carton and packaging, in case you need to
transport the telephone.

7

For your reference, keep a record of the date purchased.
Please save sales receipt for warranty reference.

Date of Purchase ____________________

INSTALLATION
CAUTION

1. Never install telephone wiring during a lightning storm.

2. Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.

3. Never touch uninsulated telephone wires or terminals unless the incoming
telephone line has been disconnected at the network interface.

4. Use caution when installing or modifying telephone lines. Note: Refer to “FCC
Requirements” section on page 18 before connection to telephone line.

To Connect the AC Adaptor

Connect the AC adaptor into the back of the unit. Plug the other end into the AC wall
power outlet (Fig C). Do not attach (staple, etc.) the AC Adaptor cord to the
building wall.

To Install One 9 Volt Battery

IMPORTANT NOTICE

Connect the AC adaptor Before installing the battery

One 9 volt battery (not included) is required to maintain your personalized greeting
and recorded messages during a power failure. If there is a power failure and the
battery is not installed, both your personalized greeting and recorded messages will
be lost.

8

1. Using a small Philips type screwdriver, remove the screw located in the battery
compartment on the bottom of the base and lift the battery compartment door
(Fig A).

2. Install one 9 volt battery. (Fig B)

9

3. Replace battery compartment door, and replace screw.

Note: Install a replacement battery once a year to insure proper operation of the
power failure protection feature.

The battery status is indicated by the BATT. LOW indicator. If a fresh battery
is installed, the LED indicator stays off, when the unit is in the ANSWER ON
mode. If the battery is low/not installed, the indicator will flash.

Choosing Your Location

Before making any connections, locate FA970 near an AC power outlet and a
wall telephone jack (RJ11C).

To Connect the Telephone Line

1. Plug the telephone line cord (connected to the back of the FA970) into the
modular outlet in your telephone wall jack.

2. If you are connecting your FA970 to an extension telephone, plug one end of
the extension telephone line cord to the extension line jack (located on back
of unit). Plug the other end into the telephone.