Southbend KECT-10, KECT-12, KECT-06 User Manual

ELECTRIC COUNTER
TILTING KETTLE
Job Item#
SPECIFICATIONS:
Shall be a Model ___________________________________, self-generating, electric, tilting kettle. A double wall kettle interior shall form a steam jacket around the lower 2/3 of the kettle. The jacket enclosure shall contain distilled water which is factory sealed. The bottom of the kettle shall be of hemispherical design for superior heat circulation.
The mounting base shall include the kettle mounting lugs concealed inside a rectangular enclosure and a stainless steel mechanism housing.
A removable operating handle with heat proof knob shall be mounted on the right.
Construction shall be of all welded satin finish stainless steel, type 304. The interior cooking surface shall be of type 316 stainless steel for added resistance to corrosion. The kettle shall be ASME constructed and National Board Registered.
The controls shall be integrally mounted and shall include a power switch, solid state thermostat, pilot light, vacuum/ pressure gauge, safety valve, low water light, and low water shut off.
The kettle shall operate in a temperature range of 100°F to 290°F (40°C to 140°C) at a maximum pressure of 50 psi (345 kPa). The kettle shall be standard with removable elements.
MODE L
KECT-6 7.5 6 23
KECT-10 12 10 38
KECT-12 12 12 45
OPERATION SHALL BE BY:
Electrically, self-generating closed steam system equipped for operation on:
The kettle shall be equipped for operation on:
208 VAC, 1 phase, 60 Hz
208 VAC, 3 phase, 60 Hz
240 VAC, 1 phase, 60 Hz
240 VAC, 3 phase, 60 Hz
STANDARD FEATURES:
Low water level cut-off and indicator
Pressure gauge
Temperature control
Safety relief valve
Type 316 stainless steel liner
2/3 steam jacket
50 PSI (345 kPa) high pressure operation for higher cooking
temperature
Integrally mounted controls Removable elements
“Clean lock” to hold kettle in cooking position or 105° for ease
of cleaning
Stainless steel console and trunnion
Water resistant construction
OPTIONAL ITEMS AT EXTRA COST:
220 VAC, 1 phase, 50/60 Hz
220 VAC, 3 phase, 50/60 Hz
380 VAC, 3 phase, 50/60 Hz
415 VAC, 3 phase, 50/60 Hz
480 VAC, 3 phase, 50/60 Hz
415/240 VAC, 3 phase, 4 wire, 50/60 Hz
380/220 VAC, 3 phase, 4 wire, 50/60 Hz
Etched gallon markings
Etched liter markings
ACCESSORIES:
One piece lift-off stainless steel cover
Stainless steel wire basket
18" high floor stand c/w sliding drain pan and stationary drain
Graduated measuring strip
Single pantry faucet with swing spout
Double pantry faucet with swing spout
CAPACITIES
Form KECT Rev 0 (01/07)
www.yatesgd.com www.yatesgraphicdesign.com
Printed in USA
Models:
KECT-6 KECT-10 KECT-12
DIMENSIONS
Model Capacity Units A B C D E F G H J K L
KECT-6
KECT-10
KECT-1212gallons45
6 gallons
23 litersin(mm)
10 gallons
38 litersin(mm)
liters
(mm)
in
MODE L PHASE KW
KECT-6
KECT-10/12
ELECTRICAL CONNECTIONS: to be specified on dataplate.
1 7.5 36.0 34.1 31.3 - - -
3 7.5 20.8 19.7 18.1 11.4 10.4 9.0
1 12.0 57.6 54.5 50.0 - - -
3 12.0 33.3 31.5 28.9 18.3 16.7 14.5
12"
(305)
16"
(406)
14.38" (365)
15"
(381)
17"
(432)
24"
(610)
26"
(660)
28"
(711)
ELECTRICAL CHARACTERISTICS
33.5"
(85.1)
34.88 (886)
36.88 (937)
208V 220V 240V 380V 415V 480V
SERVICE CONNCETIONS
15.25" (387)
17.25 (438)
22.25" (565)
26.25 (667)
AMPS PER LINE
4.75" (121)
4.88" (124)
4.38" (111)
27"
(686)
28"
(711)
30"
(762)
3.75" (95)
5.75"
(146)
12.38" (314)
14.75" (375)
10"
(254)
12.75" (324)
12.75" (324)
Form KECT Rev 0 (01/07)
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
www.yatesgd.com www.yatesgraphicdesign.com
Loading...