Southbend GS/15SC, GB/15SC General Manual
CONVECTION OVEN
MaraThONEr GOld
GAS, SINGLE DECK
Standard Features
- ENERGY STAR® qualied (standard depth only)
- Patented, high efciency, non-clog Jet Stream burners
- 90,000 BTU (NAT or LP)
- Available standard and bakery depths
- Single deck convection oven is 57-1/2” in height (with
optional casters)
- Patented “plug-in, plug-out” control panel - easy to service
- Stainless Steel front, sides and top
- Stainless steel rear jacket
- Dependent doors with windows
- Coved, fastener-free, porcelain interior
- Heavy duty, cool touch, stainless steel door handle
- Soft Air, two speed, 1/2 hp, fan motor
- 11-position rack guides and 5 plated oven racks
- Electronic ignition with solid state temperature controls
- Forced cool down fan mode
- Oven “ready” light -cycles with burners
- Interior oven lights
Available Controls
GS/15SC, GS/15CCH,
GB/15SC, GB/15CCH
Job Item#
SC-Standard Controls
140°F to 500°F solid state thermostat and 60 minute
mechanical cook timer.
CCH-Cycle / Cook & Hold Control
150°F to 500°F temperature controller with 140°F to 200°F
“Hold” thermostat Dual digital display shows time and
temperature. A fan cycle timer pulses the fan.
STANDARD CONSTRUCTION SPECIFICATIONS
Exterior Finish: Stainless steel front, sides, top and rear
jacket.
Doors: Dependent doors with windows. Stainless steel
construction, heavy-duty welded steel frame and 5/8” diameter
full-length hinge pin.
Oven Interior: Porcelain enamel nish, coved, fastener free.
Rack and Rack Guides: Heavy-duty removable wire rack
guides spaced on 1-5/8” centers offer 11 different rack
positions. 5 wire racks provided with each oven.
Blower Fan and Motor: 1/2hp, 2-speed motor, 1725/1140
r.p.m
Legs: 26” Stainless steel, triangular legs standard.
(GS/15SC shown with optional casters)
Oven Heating: 90,000 BTU (NAT or LP). Oven heating is
regulated by an adjustable solid state thermostat control. Jet
Stream style burners direct ame towards rear of combustion
chamber. Combustion products are drawn into oven interior
and recirculated prior to venting.
Electronic Ignition: Hot surface ignitor with ame safety
device.
Control Panel: Located of front, at right side of oven, away
from heat zone. Removable panel opens downward for easy
servicing.
Interior Lights: Two 40 watt high temperature recessed
lamps located within the oven cavity.
Note: Oven cannot be operated without fan in operation.
From G/15 Rev 6 (May/2010)
www.yatesgd.com www.yatesgraphicdesign.com
Printed in USA
Models:
GS/15SC GB/15SC GS/15CCH GB/15CCH
Dimensions -in (mm)
17”
(432)
20”
20”
Shown with
optional casters.
reduces height
28.25”
(718)
28.25”
(718)
12.75”
(324)
DEpth OvEn IntErIOr rack cLEarancE ShIppIng cratE
MODEL
a B c WIDth DEpth hEIght WIDth DEpth WIDth DEpth hEIght vOLuME
GS/15
GB/15
Note: When shipped on legs, crated height is 69” (1753 mm)
39.75”
(1010)
46.75”
(1187)
30”
(763)
36.38”
(924)
34.38”
(873)
40.75”
(1035)
29”
(737)
29”
(737)
22.5”
(572)
(711)
(508)
28”
(508)
UTILITY INFORMATION
GAS: • Standard and Bakery Depth: 90,000 BTU (NAT ro LP) per
oven cavity
• One 3/4” male connection
• Required minimum inlet pressure:
- Natural gas 7” W.C.
- Propane gas 11” W.C.
ELECTRIC: Standard: 120/60/1 phase, furnished with 6’ cord w/3- prong
plug (1 plug/deck). NEMA #5-15p. Total maximum amps 7.9.
Optional: 208/60/1 (190-219 volts). Supply must be wired to junction box
with terminal block located at rear. Total maximum amps 4.3 per deck.
Optional: 240/60/1 (220-240 volts). Supply must be wired to junction box
with terminal block located at rear. Total maximum amps 3.8 per deck.
Optional: 240/50/1 (208-240 volts). Supply must be wired to junction box
with terminal block located at rear. Total maximum amps 6.0 per deck
Shown with
optional casters.
Legs only
by 3”
22”
(559)
27.25”
(692)
48”
(1220)
48”
(1220)
57”
(1448)
57”
(1448)
46”
(1168)
46”
(1168)
(1.85 cu. m.)
(1.85 cu. m.)
Legs only
reduces height
by 3”
65.2 cu. ft.
65.2 cu. ft.
MISCELLANEOUS
• If using ex hose connector, the I.D should not be smaller
than 3/4” and must comply with ANSI Z 21.69.
• If casters are used with ex hose, a restraining device
should be used to eliminate undue strain on the ex hose.
• Clearances from combustibles: Top-0”, bottom-0”, right
side-0” and left-3”
• Recommend - install under vented hood
• Check local codes for re and sanitary regulations
• If the unit is connected directly to the outside ue, an
A.G.A approved down draft diverter must be installed at
the ue outlet of the oven
• Oven cannot be operated without fan in operation
Notice: Southbend reserves the right to change specications and product design without notice. Such revisions do
not entitle the buyer to corresponding changes, improvements, additions, or replacements for previously purchased
equipment.
WEIght
620 lbs
(281.2 kg.)
690 lbs
(313.0 kg.)
Stainless Steel oven interior
Stainless Steel exterior bottom
6” stainless steel legs
208/240V 50/60 cycle (for use on single
phase only)
From G/15 Rev 6 (May/2010)
OPTIONS AND ACCESSORIES
Bolt-down anged legs
Swivel Caster - front with locks
Knocked down packaging
Export Crating
Extra oven racks
Down draft diverter for direct ue
3/4” quick disconnect with exible hose
(specify length: 3ft, 4ft, or 5ft)
2” air insulation panel ( stainless steel
only)
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE.
1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
Loading...