Southbend GCX-10S-10 User Manual

Gas Compartment steamer

W

ith Kettle and Gas Fired

s

team Boiler

Job Item#

SPECIFICATIONS:

Shall be a Southbend model ____________________________,
convection steamer complete with 6 or 10 Gallon Kettle on a modular

gas red steam boiler base, with stainless steel type 304 exterior and
#4 nish, deck mounted faucet valve, swing nozzle and integral sink

with common drain.
The convection steamer shall have doors with a removable inner liner

of stainless steel, full perimeter gasket seal, outer shell of one piece, all
welded, stainless steel, positive lock and seal mechanism and a stainless

steel drip trough connected to the drain in order to collect condensate

when doors are opened. Each cooking chamber shall be constructed
of all welded type 316 stainless steel, fully insulated and provided with

removable stainless steel pan supports and shall be:

 GCX-2S: 13.875”W x 10.875”H x 19.875”D (352 mm x 276 mm x 504 mm).

 GCX-10S: 13.875”W x 17.375”H x 19.875”D (352 mm x 441 mm x 504 mm).

Steamer controls shall be accessible through a fully removable side

panel and each compartment shall include a 60 minute mechanical timer

with ready and cooking pilot light and shall interrupt steam ow to the
chamber when the compartment door is opened during cooking cycle

and shall be reactivated when the door is closed. An audible signal will

sound at the end of the cooking cycle.
The cabinet base with gas boiler and controls shall be provided with full

perimeter painted angle frame, reinforced kettle and boiler mountings,
hinged doors with magnetic latch and 6” (152 mm) stainless steel legs
tted with adjustable bullet feet on the front and adjustable anged feet
on the rear for securing unit to the oor. Boiler controls shall include

automatic water level control, pressure gauge, water gauge glass,

operating pressure control, safety high-limit pressure control, safety
relief valve and cathodic protector. The boiler shall be ASME code
stamped and National Board registered. Unit comes standard with a
split water line, CSD-1 boiler code, “Y” - strainer, electronic ignition,

and automatic blowdown.

Model description

GCX-2S-6

GCX-2S-10

GCX-10S-6

GCX-10S-10

6 pan steamer with 6 gallon

kettle and 250,000 BTU boiler.

6 pan steamer with 10 gallon

kettle and 250,000 BTU boiler.

10 pan steamer with 6 gallon

kettle and 250,000 BTU boiler.

10 pan steamer with 10 gallon

kettle and 250,000 BTU boiler.

pan capacity per coMpartMent

1” 2-1/2” 4” 6”

10 5 3 2

pan depth

6 3 2 1

OPERATION SHALL BE BY:

Gas heated steam boiler operating at 9 -11 psi (62 - 76 kPa).
The controls shall be equipped for operation on 115 VAC,
single phase 50/60 Hz.

Natural Gas
LP Gas

OPTIONAL ITEMS AT EXTRA COST:

300,000 BTU
208-240 VAC operation (specify voltage)
Stainless steel rear panel
Stainless steel frame
Correctional package
Adjustable front anged feet
Load compensating timers

ACCESSORIES:

Spray and rinse assembly



Steam take-off kit (STOK)



Form GCX2-6 Rev 5 (March/2015)

www.yatesgd.com www.yatesgraphicdesign.com

Models:

s

B

C

A

3.5 [89]

GCX-2S-6 GCX-2S-10 GCX-10S-6 GCX-10S-10

Model shipping Weight

GCX-2S-6 980 lbs. [445 kg.]
GCX-10S-6 1000 lbs. [454 kg.]
GCX-2S-10 1030 lbs. [467 kg.]

GCX-10S-10 1020 lbs. [462 kg.]

SERVICE CONNECTIONS

– ELECTRICAL CONNECTION: 1/2” (13 mm) conduit connection to controls. 120 VAC-60Hz-1PH.
2 Amps per compartment or as specied on data plate.

– BOILER FEED WATER: 1/2” (13 mm) NPT at 25-50 PSI (170-345 kPa).

– CONDENSATE COLD WATER: 1/2” (13 mm) NPT at 25-50 PSI (170-345 kPa) (OPTIONAL)

– GAS CONNECTION: 3/4” (19 mm) IPS supply line required.

– STEAM TAKE-OFF CONNECTION: 3/4” (19 mm) IPS optional to operate adjacent equipment.

– HOT WATER: 3/8” (10 mm) O.D. tubing at 25-50 PSI (170-345 kPa).

– DRAIN: 2” (51 mm) IPS piped to open oor drain. No solid connection.

– SINK DRAIN: 1 1/8” (29 mm) O.D. tubing.

GAS SUPPLY

BtU/hoUr kW/hoUr

250,000 73.3

300,000 87.9

natUral propane

7” - 14”

[178 mm - 355 mm]

Model a B c

GCX-2S-6 59.5 [1511]

GCX-10S-6 72.5 [1842]

GCX-2-10 59.5 [1511]

GCX-10S-10 72.5 [1842]

66.13 [1680] 44 [1118]

65.13 [1654] 48 [1219]

Water colUMn pressUre

11” - 14”

[279 mm - 355 mm]

WATER QUALITY STATEMENT

Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local water
treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:

Total dissolved solids ....................Less than 60 PPM

Total alkalinity ................................Less than 20 PPM

Silica ...............................................Less than 13 PPM

Chlorine .........................................Less than 1.5 PPM

pH Factor ......................................7.0 - 8.5

Water which fails to meet these standards should be treated by installation of water conditioner.

FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY.
CONTACT SOUTHBEND FOR WATER QUALITY SOLUTIONS.

INTENDED FOR COMMERCIAL USE ONLY.

.

Form GCX2-6 Rev 5 (March/2015)

NOT FOR HOUSEHOLD USE

1100 Old Honeycutt Road, Fuquay-Varina, NC 27526

[phone] www.southbendnc.com