Southbend ECX-2 General Manual

OPERATION SHALL BE BY:

Electrically heated steam boiler operating at 15 psi
(103 kPa) and rated at:

䡺 24.0 kw (standard)
䡺 36.0 kw
䡺 42.0 kw
䡺 48.0 kw

The steam boiler shall be equipped for operation on:

䡺 208 VAC, 3 Phase, 60 Hz
䡺 230 VAC, 3 Phase, 60 Hz
䡺 240 VAC, 3 Phase, 60 Hz

The controls shall be equipped for operation on 115VAC,
1 Phase, 60 Hz

OPTIONAL ITEMS AT EXTRA COST:

䡺 Solid state digital controls
䡺 Automatic boiler blow down
䡺 220 or 240 VAC, 1 Phase, 50 Hz
䡺 Two water lines (boiler feed and condensate)
䡺 De-lime piping assembly (DPA-1)
䡺 Stainless steel frame
䡺 Cabinet size (36", 48")
䡺 Stainless steel back on cabinet
䡺 California State boiler code requirement
䡺 CSD-1
䡺 380 VAC, 3 Phase, 50 Hz
䡺 415 VAC, 3 Phase, 50 Hz
䡺 480 VAC, 3 Phase, 60 Hz
䡺 Correctional package

ACCESSORIES:

䡺 Spray and rinse assembly
䡺 12" x 20" x 2.5" perforated stainless steel pan
䡺 12" x 20" x 2.5" solid stainless steel pan
䡺 12" x 20" x 4" perforated stainless steel pan
䡺 12" x 20" x 4" solid stainless steel pan
䡺 Adjustable flanged feet
䡺 Ball float trap
䡺 Water in strainer
䡺 Steam take-off kit

SPECIFICATIONS:

Shall be a Model

ECX-2

electric convection
steamer with electric steam boiler. The steamer shall be
constructed of satin finish stainless steel, type 304, with a
cooking chamber of one-piece all-welded stainless steel. The
doors shall have a removable inner liner of stainless steel
with full perimeter gasket seal, an outer liner of one-piece all­welded stainless steel, and a positive lock and seal
mechanism with spring release. The door opening shall be
10" x 14" (254 x 356 mm). The steamer shall be provided
with removable stainless steel pan supports and a stainless
steel drip trough connected to drain to collect condensate
when door is opened.

The control housing shall be constructed of stainless steel
with a full access removable panel. The controls shall include
an illuminated on/off power switch. The timing of each
compartment shall be independently controlled by a pilot
ready light, a pilot cooking light and a 60 minute electric timer
which sounds an audible signal at the end of the cooking
cycle. Steam flow to the chamber shall be cut off when the
door is opened during the cooking cycle and shall be
reactivated when the door is closed.

The convection steamer shall be mounted on a cabinet base
with full perimeter angle frame, reinforced counter and boiler
mountings, electric boiler with controls, all stainless steel
exterior, hinged doors and 6" (152 mm) stainless steel legs
with adjustable bullet feet.

Model Compartments Capacity

ECX-2 2 4-12 Pans

Shown on Optional 36" Cabinet

Base and Digital Controls

ELECTRIC STEAMER

A Middleby Company

WITH

CABINET BASE

Job Item#

Form ECX-2

A Middleby Company

08/04 Printed in USA

Models:

10/01

IN (mm)

– Cold Water: 1/2" (13 mm).

– Drain: 2" (51 mm) IPS piped to open floor drain. No solid connection.

– Electrical connection: 1/2" (13 mm) conduit connection to controls. 2 Amps per compartment, 120-60-1 or 220-50-1.

– Steam Take-off Connection: 3/4" (19 mm) optional to operate adjacent equipment.

– Electric Power Connection to Boiler: Sized for at least 90°C per line.

SERVICE CONNECTIONS

DIMENSIONS

MODEL UNITS A B C D E F G H J K L M N O P Q R S T U
ECX-2 inches 36 24 33 14 6 28 58 6 8 14 22 5 6 4 6 2 4 6 11 5

mm 914 608 838 357 152 711 1479 152 203 357 559 127 152 102 152 51 102 152 279 127

EP

208V 230V 240V 380V 415V 480V
MODEL KW AMP KW AMP KW AMP KW AMP KW AMP KW AMP
ECX-2 24 66.6 24 60.3 24 57.8 24 36.5 24 33.4 24 28.9

36 100.0 36 90.4 36 86.7 36 54.7 36 50.1 36 43.3
42 116.6 48 120.6 48 115.6 48 73.0 48 66.8 48 57.8

ELECTRICAL CHARACTERISTICS

 ECX-2

Form ECX-2

INTENDED FOR COMMERCIAL USE ONLY.

NOT FOR HOUSEHOLD USE.

1100 Old Honeycutt Rd., Fuquay-Varina, NC 27526

www.southbendnc.com