Southbend ECX-10 User Manual

SPECIFICATIONS:

Shall be a Southbend Model _____________________________,
convection steamer with electric steam boiler base, ASME code stamped
and National Board registered. The steamer shall be constructed of #4
nish stainless steel type 304, with a cooking chamber of one-piece, all
welded, 316 stainless steel and shall be:

 ECX-2, 13.875” W x 10.875” H x 19.875” D (352 mm x 276 mm x 504 mm).

 ECX-10, 13.875” W x 17.375” H x 19.875” D (352 mm x 441 mm x 504 mm).

The chamber shall be fully insulated and provided with removable
stainless steel pan supports. The doors shall have a removable inner
liner of stainless steel with full perimeter gasket seal, an outer shell of
one piece all welded stainless steel, a positive lock and seal mechanism
and a stainless steel drip trough connected to drain to collect condensate
when door is opened.

Steamer controls shall be accessible through a full removable side panel
and each compartment shall include a 60 minute mechanical timer with
ready pilot and cooking pilot light and shall interrupt steam ow to the
chamber when the door is opened during cooking cycle and shall be
reactivated when the door is closed. An audible signal which will sound
at the end of the cooking cycle.

The cabinet base with electric boiler and controls shall be provided
with full perimeter angled frame, reinforced boiler mountings, gas boiler
with controls, all stainless steel exterior, hinged door(s) with magnetic
latch and 6” (152 mm) stainless steel legs tted with adjustable bullet
feet on the front and adjustable anged feet on the rear for securing to
the oor. Standard boiler controls shall include automatic water level
control, pressure gauge, water gauge glass, operating pressure control
with pressure safety control, safety relief valve and cathodic protector.

ElEctric convEction StEamEr

on cabinEt baSE

Compartment pan CapaCity

model Standard Boiler

ECX-2 24 kW 6 3 2 1

ECX-10 36 kW 10 5 3 2

OPERATION SHALL BE BY:

Electrically heated steam boiler operating at 9 - 11 psi (62 - 76
kPa) and rated at:

 24.0 kw (ECX-2 standard)

 36.0 kw (ECX-10 standard)

. The steam boiler shall be equipped for operation on:

 208 VAC, 3 Phase, 60 Hz

 240 VAC, 3 Phase, 60 Hz

The controls shall be equipped for operation on 115 VAC, 1
Phase, 60 Hz

OPTIONAL ITEMS AT EXTRA COST:

 36.0 kw

 42.0 kw

 48.0 kw (240 VAC min.)

 220 VAC, 3 PHASE, 60 Hz

 380 VAC, 3 PHASE, 60 Hz

 415 VAC, 3 PHASE, 60 Hz

 480 VAC, 3 PHASE, 60 Hz

 600 VAC, 3 PHASE, 60 Hz

 380/220 VAC, 3 PHASE, 60 Hz, 4 wire

 415/240 VAC, 3 PHASE, 60 Hz, 4 wire

 CSD-1

 Automatic boiler blow down

 36” wide cabinet

 Stainless steel rear panel

 Stainless steel frame

 Split water line

 Adjustable front anged feet

 Load compensating timers

 Cabinet size (48" or 60")

 Correctional Package

ACCESSORIES:

 Spray and rinse assembly

 De-liming kit (DPA-1) not available with CSD-1

 Water in “Y” strainer

 Steam take-off kit (STOK)

1” 2-1/2” 4” 6”

pan depth

Job Item#

Form ECX Rev 1 (December/2010)

www.yatesgd.com www.yatesgraphicdesign.com

Printed in USA

Models:

READY COOKING

COOKINGREADY

 ECX-2  ECX-10

model

ECX-2 550 lbs. [249 kg] 650 lbs. [255 kg]

ECX-10 575 lbs. [260 kg] 700 lbs. [317 kg]

Shipping Weight

(24” CaBinet)

Shipping Weight

(36” CaBinet)

minimum ClearanCe

SIDES

BACK

0
0

SERVICE CONNECTIONS

– ELECTRICAL CONNECTION: Rating to be as specied on data plate.

– COLD WATER: 3/8” (10 mm) O.D. tubing at 25-50 psi (170-345 kPa).

– DRAIN: 2” (51 mm) IPS piped to open oor drain. No solid connection.

– STEAM TAKE-OFF CONNECTION: 3/4” (19 mm) IPS optional to operate adjacent equipment.

ELECTRICAL CHARACTERISTICS

aVailaBle kW

model Standard optional

ECX-2 24 36, 42, 48

ECX-10 36 42, 48

kW phaSe 208V 220V 240V 380V 415V 480V

24 3 66.6 63.0 57.8 36.5 33.4 28.9

36 3 99.9 94.5 86.6 54.7 50.1 43.3

42 3 116.6 110.2 101.0 63.8 58.4 50.5

48 3 N/A N/A 115.5 72.9 66.8 57.7

ampS per line

WATER QUALITY STATEMENT

Water quality is the major factor affecting the performance of your appliance. If you are unsure of water quality, consult a local water
treatment specialist and have the water analyzed. Your water supply must be within these general guidelines:

Total dissolved solids ....................Less than 60 PPM

Total alkalinity ................................Less than 20 PPM

Silica ...............................................Less than 13 PPM

Chlorine .........................................Less than 30 PPM

pH Factor ......................................7.0 - 8.5

Water which fails to meet these standards should be treated by installation of water conditioner.

FAILURE OR MALFUNCTION OF THIS APPLIANCE DUE TO POOR WATER QUALITY IS NOT COVERED UNDER WARRANTY.
CONTACT SOUTHBEND FOR WATER QUALITY SOLUTIONS.

INTENDED FOR COMMERCIAL USE ONLY.

NOT FOR HOUSEHOLD USE.

1100 Old Honeycutt Road, Fuquay-Varina, NC 27526

Form ECX Rev 1 (December/2010)

[phone] www.southbendnc.com