Page 1
Welcome
Wecome to use 2.4GHz Wireless mouse and The receiver of the wireless mouse
Product Overview
Products Features
u Built in latest 2.4GHz wireless solution, Lower energy consumption and stable performance
u Working distance over 5meters
u 2.4GHz Wireless mouse 1PCS AA 1.5V battery need to use
u Resolution：1200dpi
u On/off power switch
u The receiver of the wireless mouse power is DC 5V
Installation
1. Open the battery cover on the bottom of the mouse, Take off the Nano receiver
2. Put 1PCS AA battery into the mouse body, and close the battery cover
3. Put the Nano receiver into the USB port of your computer
4. Turn on the power switch
5. After connection you may start to use the wireless mouse
Troubleshooting
If the wireless mouse doesn’t work properly, Please try the below steps:
1. Check the battery, please replace the new one if it is ran out of power
2. Please try to connect the Nano receiver to other USB port
3. Check the Power switch status, make sure the power switch on
Remarks
If mouse is stay out of work for 10minutes,it will turn to power saving mode, Press any button to
restart it; You can switch off the mouse to save power.
Page 2
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Loading...