Soundtube SA502 User Manual

SA502

Install Instructions For:

SA502.

Box Contents

1- Amplier

1- Stereo RCA to mini adapter
(UL 60065 compliant)

1- 32 V, 3.75 A power supply

2- Four-pin Euroblock connectors

3- Three-pin Euroblock connectors

1- Mounting bracket

Faceplate

Faceplate screws (4)

SA502 amplier

Four-pin Euroblock

Six-pin jumper block

Two-pin jumper block

Three-pin
Euroblock (3)

Four-pin Euroblock

Three-pin Euroblock (3)

Front Rear

Warning

SoundTube products must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.

Mounting bracket

1.435.647.9555

© 2012 SoundTube Entertainment, Inc. All rights reserved. PN INS-SA502 Rev01.27.12

|

800.647.TUBE

|

www.soundtube.com

SA502

Install Instructions For:

SA502.

1. Unpack amplier.

Note: Follow steps 2-5 if
using the mounting adapter.
If not skip to step 6.

5. Replace faceplate and
screws.

2. Attach mounting bracket
to a secure pole or surface
using screws or metal
strapping.

6. Select stereo, bridged or
mono mode with the
included jumper.

3. To attach mounting
bracket, remove all faceplate
screws from one side. Lift
faceplate and set aside.

SA502

Left line in

Right line in

STEREO

Amp
(left)

Amp

(right)

7a. In stereo mode, the left
and right channels remain
separate. The amp operates
as a normal stereo amp.

4. Slide mounting bracket
into groove on bottom of
amplifer enclosure.

SA502

Left line in

Right line in

MONO

Amp
(left)

Amp

(right)

7b. In mono mode, the left
and right inputs are
combined internally and
fed to both channels of the
amp. The left and right
channels both output the
summed signal.

SA502

Left line in Amp

BRIDGED

(left)

Amp

(right)

7c. In bridged mode, the
amp becomes a mono block
amp with just one input
(left), and one output. The
bridged amp is capable of
90w in to 4 ohms.

STEREO or MONO

8a. Stereo and Mono:
connect speaker wires to 4
pin Euroblock.

BRIDGED

8b. Bridged: connect single
pair of speaker wire to the
center + and - terminals of 4
pin Euroblock. DO NOT use
outside terminals.

9. Connect speaker
Euroblock to the SA502.