SoundTube SA202-WOPS Installation Guide
Box Contents
1 Amplifier
1 Four-pin Euroblock connector
1 Three-pin Euroblock connector
1 High-level input wiring harness
1 Mounting bracket
2 Mounting screws
Install Instructions For:
SA202 and SA202-RDT
Faceplate
Amplifier enclosure
Euroblock connector
High-level input
wiring harness
Install Instructions For:
SA202 and SA202-RDT
1. Unpack amplifier. 2. Attach mounting bracket
to secure mount point using
screws or metal strapping.
3. Connect speaker wires
to 4-pin Euroblock
connector using polarity
shown above (or refer to
diagram on amplifier).
12 - 15 VDC
Barrel connection
12 - 15 VDC
Euroblock power input
4. To attach mounting
bracket, remove all
faceplate screws. Lift
faceplate and set aside.
Faceplate screws (4)
Mounting bracket
Front Rear
Volume control
High-pass filter
RCA jack
Warning
SoundTube produc ts must be installed by a professional audio installer/contractor. For safety and for
optimu m audio performance, installer must follow all direct ions issued by SoundTube Entertainment.
Mini jack
(amplified) audio input
© 2009 SoundTube Entertainment, Inc. All rights reserved. PN INS-SA202 Rev10.07.09
12 - 15 VDC
Barrel connection
High-level
1.435.647.9555
12 - 15 VDC
Euroblock power input
Euroblock speaker output
|
800.647.TUBE
|
www.soundtube.com
5. Slide mounting bracket
into groove on bottom of
amplifer enclosure.
9a. The SA202 accepts
audio sources via RCA
jacks, mini jack or the
high-level input located on
the rear of the unit.
Connect audio source to
one of the three inputs
(mini jack shown).
Euroblock power connections
_
GND REM + V
+
Without external trigger With external trigger (12-15 V)
+
If the amp is being run without
using the external trigger, simply
connect the positive lead from the
power supply to both the + V
input and the remote (REM) input.
6. Replace faceplate and
screws.
9b. If using the high-level
(amplified) inputs, wire the
source leads to the high-level
input wiring harness as
shown and insert the terminal
block into the high-power
input on the back of the
amplifier.
7. The SA202 can be
powered either by the
hard-wired Euroblock
connector (see diagram below)
or via barrel connector. The
SA202-RDT includes a power
supply which attaches to the
barrel connector.
10. Use high-pass filter to
remove low-end frequencies
and increase intelligibility
when using small speakers.
Trigger
_
+
If the amp is being run using the
external trigger, connect the
power to the ground and + V
input, and run the trigger wire
GND
REM + V
from the outside source into the
remote (REM) input.
8. Connect power and
speakers.
11. Adjust volume with dial
on front of amplifier.
12. Done!
Loading...