SoundTube RS4-EZ-WH, RS4-EZ-BK, RS1001I-II-T-SUB, HP590I-WH, HP590I-BK Installation Guide

Secure anchor point

Hanging or safety cable

SpeedClamp™

Install Instructions For:

RS4-EZ, RS400i, RS500i, HP590i, RS600i, HP690i, RS800i, HP890i, RS1001i-II, HP129i & HP1290i speakers

Box contents

1 Speaker
2 SpeedClamps™
1 Release key (small hex wrench)
1 Hanging cable
1 Safety cable
1 Terminal weather boot
1 Euroblock connector
1 Grille-mounted tap switch cover
4 Zip ties

Safety cable with clip

Signal wire

Terminal weather boot

Euroblock connector

Euroblock jack

Hanging cable with clip

RS4-EZ & RS400i tap location

Euroblock jack

Tap switch

Surface-mount
bracket insert

1.435.647.9555

RS400i, RS500i, RS600i, RS800i, RS1001i-II, HP690i and HP890i - UL listed 1480

© 2008 SoundTube Entertainment, Inc. All rights reserved. PN INS-RSI Rev 09.15.08

Warning Warning

SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.

Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.

Grille-mounted
tap switch cover

(except RS4-EZ)

|

800.647.TUBE

|

www.soundtube.com

Install Instructions For:

RS4-EZ, RS400i, RS500i, HP590i, RS600i, HP690i, RS800i, HP890i, RS1001i-II, HP129i & HP1290i speakers

1. Unpack speaker and
SpeedClamp™ mounting
hardware.

5. Thread hanging or safety
cable through SpeedClamp™
mechanisms as shown.

2. Select the tap position by
removing the rubber plug on
grille to access rotary switch.
Switch is preset to maximum
tap setting in 70.7 V mode.
Select desired setting and
reinsert rubber plug. Note: The
grille-mounted tap switch
cover is keyed; be sure flat
edge of plug lines up with flat
edge of hole in grille.

6. Attach the hanging cable
by securing it and safety
cable to structure as shown.

3. Slip terminal weather
boot over signal wire. For
environmental applications,
put RTV silicone around
nipple and base when
installation is complete.

7. Thread cable end(s)
through SpeedClamp™
mechanisms as shown.

4. Connect signal wire to
4-pin Euroblock plug. Tighten
unused terminal screws. Use
inside positive and negative
inputs for either voice coil or
distributed systems. For daisy
chaining, use outside positive
and negative terminals.

8. Adjust speaker hanging
height with SpeedClamp™
mechanism. Pull to tighten &
insert release key (small hex
wrench) into SpeedClamp ™
as shown to loosen or adjust.

9. Attach hanging cable to
the center hole in the
speaker hanging bracket.

SoundTube also provides optional surface mount brackets for both the RS and HP lines of products.

Installation instructions for these accessories are included with specific accessory packaging.

10. Attach the safety cable to

one of the secondary holes in
the hanging bracket.

11. Insert 4-pin Euroblock
plug into Euroblock jack on
rear of speaker. Connectors
are keyed for polarity.

12. Use zip or twist-lock ties
to secure safety cable & signal
wire to main hanging cables.
Cable cover available for
asthetic applications (SLT-10).