Soundtube RS42-EZ User Manual
RS-EZ series
Install Instructions For:
RS42-EZ, RS62-EZ, RS82-EZ, HP82-EZ
Cover Plate
Screws (4)
Hanging Bracket
Terminal
Block
Weather plug
Cover Plate
Hanging Hardware
Tap Switch
Box contents
1 Speaker
1 Cover Plate w/ 4 screws
1 Rubber weather plug
1 Hanging kit
Speaker
1.435.647.9555
© 2012 SoundTube Entertainment, Inc. All rights reserved. PN INS-RS-EZ Rev 03.01.12
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
|
800.647.TUBE
|
www.soundtube.com
RS-EZ series
Install Instructions For:
RS42-EZ, RS62-EZ, RS82-EZ, HP82-EZ
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
1. Unpack speaker and
SpeedClamp™ mounting
hardware.
5.
Adjust speaker hanging
height with SpeedClamp™
mechanism. Pull to tighten &
press button on SpeedClamp
as shown to loosen or adjust.
2. Thread hanging or safety
cable through SpeedClamp™
mechanisms as shown.
6. Slide cover plate over
hanging and safety cables
and run signal wire through
center hole.
3. Attach the hanging cable
by securing it and safety
cable to structure as shown.
1.
2.
7a. Attach hanging cable by
(1) inserting into side of
mounting bracket and (2)
rotating to align with center
slot in hanging bracket.
4. Thread cable end(s)
through SpeedClamp™
mechanisms as shown.
7b. Once aligned with central
slot, pull cable up into slot to
secure. Repeat steps 7a and
7b with secondary safety cable into one of the side slots.
8. Extra slot and 2 holes
provided for additional
safety cables where needed.
12. Tighten all four (4) screws
to lock cover plate in place.
9. Connect signal wires to (+)
and (-) inputs. Use extra (+)
and (-) for daisy chaining.
13. Install rubber weather
plug by sliding slit over the
wire, then pressing snuggly
into hole in cover plate.
10. Select desired tap position.
Switch is preset to maximum
70.7V (100V) mode.
14. Done.
11. Place cover plate onto
top of speaker and rotate
clockwise until alignment
indicators meet.
Loading...