Soundtube IW500i User Manual

IW

Box contents

1 Speaker
1 Grille
1 Paint mask
1 Cutout template

IW500b - includes
2 wire nuts
1 conduit camp

Clamp screw (4x)

UL 1480

Steel Backcan

Install Instructions For:

IW500i and IW500b speaker

Paint mask

Grille

1.435.647.9555

|

800.647.TUBE

|

www.soundtube.com

Tap switch

Mounting bar

IW500b: Steel signaling speaker enclosure listed UL 1480

© 2006 SoundTube Entertainment, Inc. All rights reserved. PN INS-IW500 Rev 01.04.08

Warning Warning

SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.

Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.

IW

Install Instructions For:

IW500i speaker

1.435.647.9555

|

800.647.TUBE

|

www.soundtube.com

1. Unpack speaker and

grille. Leave paint mask
in place until speaker is
ready to install.

2. Use provided cut out
template to make hole.
Use Rotozip or other tool
to cut hole in wall. Hole
size, 7.5” x 10.75”

IW500i IW500b-Backcan

4. Connect speaker wires

to terminals on rear of
speaker.

4. Connect speaker wires
to wire leads using wirenuts.
Push wire nuts into backcan
and insert conduit clamp.

3. Remove styrofoam inserts
between mounting bars and
speaker baffle. (4x)

5. Insert speaker in to hole
(bottom first) with mounting
bar on inside of wall.

6. Remove paint mask. Then
tighten the four clamping
screws. DO NOT OVER
TIGHTEN.

7. Adjust tap switch to
proper setting. Switch is
preset to maximum tap
setting in 70.7 V mode (33 W)

Note: Replace paint mask If
painting wall after speaker is
installed.

8. Insert Grille into lip of bezel
and press gently into place.