SoundTube IPD-XT850 Install Instructions Manual
IPD-XT850
Speaker enclosure
#8 Stainless-steel
square-drive screw (x6)
Install Instructions For:
IPD-XT850
1.435.647.9555
Box contents
1 In-ground speaker
1 in-ground/security bracket (2 pieces)
1 Liquid-tight RJ45 coupling compression tting
1 Square drive bit
6 #8 stainless-steel square-drive screws
2 .75" 1/4-20 Stainless-steel bolts
|
800.647.TUBE
|
www.soundtube.com
Speaker base
In-ground/security bracket
Pre-installed Cat5 Cable
RJ45 connector
Liquid-tight RJ45 coupling
.75" 1/4-20 Stainless-steel bolt
IPD-XT850
Install Instructions For:
IPD-XT850
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
1. Attach inground/security
brackets to speaker base
using stainless-steel bolts.
5. Set speaker enclosure on
speaker base. Use tamperresistant stainless-steel
screws to attach
speaker to base (driver
tip and screws provided).
2. Field route Cat5 cable
from the switch to each
IPD-XT850, direct burial
cable or use of conduit is
required. The cable may
need to be terminated after
routing the cable through
the compression tting of
the liquid-tight RJ45 coupling.
Tighten tting to seal.
6. Done!
3. Dig a hole that is 15”
wide and 5” deep. Place
speaker base ino the hole in
the ground with the top rim
of the base at ground level.
Back-ll dirt into hole. For
added security, cement
security brackets into ground.
4. Plug Cat5 cables into
coupling. No wire nuts
needed. Tighten tting to
seal.
Additional Information
Software and firmare updates for SoundTube Dante-enabled speakers can be found on our website. Go to
www.mseaudio.com/downloads and navigate to SoundTube and download the necessary software for your IPD-XT850
speaker.
Warning
SoundTube speakers must b e installed b y a p r ofessional audio
installer/contractor. For safety and for optimum audio performance,
installer must follow all directions issued by SoundTube Entertainment.
Loading...