SoundTube HP82-EZ-WH, HP82-EZ-BK Install Instructions Manual
Box contents
© 2015 SoundTube Entertainment, Inc. All rights reserved. INS-HP-EZ Rev 12.04.2014 - Rev 2
Document Reference Number RSEZ0003
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
HP-EZ series
Speaker
Cover Plate
Cover Plate
Screws (4)
Hanging Hardware
Tap Switch
Hanging Bracket
Terminal
Block
Weather plug
1 Speaker
1 Cover Plate w/ 4 screws
1 Rubber weather plug
1 Hanging kit
Install Instructions For:
HP82-EZ-WH & HP82-EZ-BK
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
1. Unpack speaker and
SpeedClamp™ mounting
hardware.
2. Thread hanging or safety
cable through SpeedClamp™
mechanisms as shown.
3. Attach the hanging cable
by securing it and safety
cable to structure as
shown.
4. Thread cable end(s)
through SpeedClamp™
mechanisms as shown.
9. Connect signal wires to
(+) and (-) inputs. Use extra
(+) and (-) for daisy
chaining.
11. Place cover plate onto
top of speaker and rotate
clockwise until alignment
indicators meet.
12. Tighten all four (4) screws
to lock cover plate in place.
5.
7a. Attach hanging cable
by (1) inserting into side of
mounting bracket and (2)
rotating to align with center
slot in hanging bracket.
6. Slide cover plate over
hanging and safety cables
and run signal wire through
center hole.
10. Select desired tap
position. Switch is preset to
maximum 70.7V (100V)
mode.
7b. Once aligned with central
slot, pull cable up into slot to
secure. Repeat steps 7a and
7b with secondary safety cable into one of the side slots.
Adjust speaker hanging
height with SpeedClamp™
mechanism. Pull to tighten &
press button on SpeedClamp
as shown to loosen or adjust.
13. Install rubber weather
plug by sliding slit over the
wire, then pressing snuggly
into hole in cover plate.
14. Done.
8. Extra slot and 2 holes
provided for additional
safety cables where
needed.
1.
2.
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
Install Instructions For:
HP82-EZ-WH & HP82-EZ-BK
HP-EZ series
Loading...