Soundtube FP6020-II User Manual
FP Series
FP Series
Cable hanging bracket
Right pair - Red Black
Left pair - White Green
Signal wire/ hanging cable (4.5m /15 ft)
Install Instructions For:
FP6030 and FP6020 speakers
Dome clamp
Mounting bushing
CAT V cable
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
Box contents
1 FP pod w / signal wire / hanging cable
1 FP Dome clamp
1 Cable hanging bracket
1 Mounting bushing
1 FP dome (in separate box)
FP dome
FP speaker pod
Mono Operation:
High pass filter switch (on position)
Series - 16 Ohm
Right pair - R e d B l a c k
Source Source
Left pair - W h i t e G r e e n
Source
Parallel - 4 Ohm
Warning Warning
SoundTube speakers must be installed by a professional audio
installer/contractor. For safety and for optimum audio performance,
installer must follow all directions issued by SoundTube Entertainment.
Do not spec or install speaker near support beam, ventilation
duct or other structure that may interfere with speaker function
or dispersion.
Right pair - R e d B l a c k
© 2005 SoundTube Entertainment, Inc. All rights reserved. PN INS-FP6 REV 03.01.05
Left pair - Green White
FP Series
FP Series
Install Instructions For:
FP6030 and FP6020 speakers
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
1. Unpack FP speaker pod
and FP Dome.
5. To use hanging cable:
Attach mounting bushing
to cable hanging bracket.
Thread signal wire thru
mounting bushing, adjust
height of dome and tighten
bushing.
2. Thread signal wire through
hole in dome and dome clamp.
6. Connect signal wire
to audio source.
Note - For Mono operation see
diagram on reverse side.
3. Hand tighten dome clamp.
7. Adjust audio level
for ambient sound levels.
See chart below for
recommended levels.
4. To use junction-box w/
face plate (not supplied):
Attach mounting bushing to
J-box. Thread signal wire thru
mounting bushing, adjust height
of dome and tighten bushing.
8. Turn high pass filter on or
off. When switch is in “up”
position, signal is full-range.
Note - In full-range, bass frequencies
will bleed outside the dome due
to their longer wavelengths.
Hanging height Guidelines
Hang dome 1.5 to 2.0 feet above listener.
Guidelines for setting the SPL
1. Measure ambient noise level of the venue at the busiest time.
2. Stand under the dome and set volume level to +6 dB above the
ambient noise level measurement.
3. Step outside the dome and check to see that the SPL of the
Dome is not too loud as compared to the ambient noise level.
4. Adjust Equalization to match the program music being played.
*Note - Bass frequencies will bleed outside the dome due to
their longer wavelengths.
5. Adjust SPL as necessary. This level will vary based upon the
height of the dome.
1.5 ft to 2.0 ft
45.72 cm to 60.96 cm
Loading...