Soundstream SC40C Owner's Manual
SPECIFICATIONS
Model: SC20C
20 Farad Hybrid Super Capacitor (Carbon And Electronic
Capacitor) With Blue Digital Voltage Display, Blue Flash LED
Capacitance ............................................ 20,000,000 micro farad
Working Voltage ........................................... 16DC
Surge Voltage ................................................ 18DC
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25 °C
Capacitance Tolerance--------------------------- ± 10%
Model: SC40C
40 Farad Hybrid Super Capacitor (Carbon And Electronic
Capacitor) With Blue Digital Voltage Display, Blue Flash LED
Capacitance ............................................ 40,000,000 micro farad
Working Voltage ........................................... 16DC
Surge Voltage ................................................ 18DC
E. S. R. (Equivalent Series Resistance)........... 0.0015 ohm @120hz/25 °C
Capacitance Tolerance.................................... ± 10%
DETAILED FEATURES:
4 digits hi-end blue light display DC voltage meter that can measure 0.1
a)
DCV range.
Reverse pole connecting PCB buzz warning function. If the capacitor is
b)
connected incorrectly by reversing the positive and negative wires
during the installation process the PCB will issue a 45 second noise to
warn you.
Hi-end platinum plated 100% brass solid parts and chrome plated metal
c)
cover
Over voltage limit and low battery voltage limit warning. When the
d)
system voltage peeks over 17 DCV or LESS than 10 DCV. The buzzer
on the PCB will issue an audible noise warning.
Multiple small capacitance capacitors linked to provide the lowest inner
e)
E.S.R. and largest moment discharge power.
1
To Charge the capacitor:
1.
Make Capacitor positive terminal connections with amplifier and
tighten the bolt. Do not over-tighten the bolts!
Caution: Stripped terminals are not covered under the capacitor's warranty.
2.
3.
4.
Connect the ground cable with battery, amplifier, then refer to the
attached drawing.
Place the supplied charging bulb between positive terminal of the
capacitor and the battery's positive terminal. Do this for 2 ~ 3
minutes or until the charging bulb goes out.
Caution: The charging bulb will get hot!
Immediately take out the charging bulb from the connecting wire
after the charging process. And connect the positive cable of the
battery directly to the positive terminal on the capacitor.
DISCHARGING THE CAPACITOR:
When you want to take out the capacitor after you finish the installation
process from original car audio system. You must do discharge process
when you want to move the capacitor. It will be safe to release the
power of the capacitor.
3
Loading...