Page 1
USER'S MANUAL
Portable PA System for MP3
CH 3
2
H
C
H 1
C
INSTRUMENT/MIC 2
BALANCED
1
MIC
GAIN
0
10 10
0
USB
USB/SD DIGIT AL P LAYER
R
SD
L
IN
APE
T
GAIN
GAIN
10
0
10
EQ
V+ V-
USB/SD
POWER
VOL
BASS
MASTER
MIDDLE
TREBLE
0
0
0
0
+15
5
1
+1551 +1551
Please read this manual carefully and proper take care of this manual
Page 2
6. IMPORTANT NOTE
Use this troubleshooting guide if : The sound is distorted at high volumes.
Input is clipping: Try lowering the input gain or the volume control on your sound sou rce or music instrument.
Output is clipping: Lower the main volume level.
There is too much bass: Try adjusting the tone or EQ control on your sound source to
lower bass level. This will allow you to play the music louder
before clipping (distortion) occurs.
The link cable: is being plugged into the instrument or MIC input instead of the RCA line
input.
7. SPECIFICATIONS
Input Voltage: AC 110-120V/60Hz 220-240V/50Hz
Output Wattage: 8" (peak) 22W
10" (peak) 50W
Output Wattage: 8" (RMS) 15W, 1% THD
10" (RMS) 30W, 1% THD
Frequency Response: 70~50kHz +/-3dB
Bottom pole mount specifications: Standard Pole Mount found at professional audio
retailer.
Depth 97mm(3.819")
Diameter 37mm(1.457")
Battery life: Over 6 hours* at full volume of the system when fully charged.
dimensions
(W x D x H) 8" 386x307x456mm
15.197＂x 12.087＂x 17.953＂
10" 437x340x507mm
17.205＂x 13.386＂x 19.961＂
Weight: 8" 17.5 kg
10" 22.5
NOTE: Battery life may vary based on temperature, age and volume usage of product.
(5)
Page 3
(10) Pr otect the power cord from being walked on or pinched particularly at plugs, ext ension
cords , an d th e po int at w hich they exit the unit.
4. FEATURES
(11) Only use attachments/accessories spe cified by the manufact urer.
(12) Us e on ly w ith the cart, stand, tripod, bracket, or tabl e sp ecified by the manufac turer, or
sold with the dev ice. When a cart is used, use caution w hen moving the cart/ devic e
combi nation to avoid injury from stumbling over it.
(13) Un plug this device durin g li ghtning storms or when not used for long periods of time.
(14) Re fer all servicing to quali fied service personnel. Servicing is required when the unit has
been dama ged in a ny w ay, such as power supply cord or plug is damaged , li quid has b een spill ed o r ob jects have fallen into the device, the unit has been expo sed to r ain or
moist ure, does not operate normally, or h as b een dropped.
3 INTRODUCTION.
FULLY CHARGE THE BATTERY BEFORE FIRST USE FOR MAXIMUM BATTERY LIFE
1. Make sure all items.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT.
3. MAKE SURE THAT YOU HAVE COMPLETELY CHARGED THE BATTERY.
4. Study this setup diagram.
5. Place product in an appropriate position for operation.
6. Make sure all input devices such as microphones, CD or SD players, USB players, MP3
players, and linked amplifiers/PAS are turned off and volume settings are set at “zero”
7. Connect all devices as shown above.
8. Connect the outputs to the power amplifier(s), tape decks, and / or audio sources.
9. Switch everything on in the following order.
* audio input sources (i.e. Microphones, instruments, CD players,USB or SD players,MP3
players)
* last, any amplifiers.
10. When turning off ,always reverse this operation by ,
* turning off amplifiers
* last, any input devices.
C H 1 C H 2 C H 3
R
L
MIC 1 IN
BAL
LEVEL
0 10
INS/MIC 2 IN
UNBAL
LEVEL
0 10
CD/TAPE IN
LEVEL
0 10
(1) (2) (3) (4) (5)
CHARGE
ON
POWER INPUT
AC 230V 5 0/60Hz
T0.5A/250 V
OFF
POWER
LINK
OUTPUT
SOUND SYSTEM
BATTERY LEVEL
LOW
USB
0
+1551
USB/ SD D IGITA L PL AYER
V+ V-
MIDDLE
0
+1551
BASS
EQ
USB/SD
POWER
MASTER VOL
0
0 10
+1551
SD
TREBLE
(6)
3
2
1
(7) (8) ( 9) (10)
(1). Microphone 1 Balanced Input with Control (1/4” and XLR):
Level
This jack can either take a 1/4” balanced or a XLR balanced cable. An XLR Cable is inc-
luded with the microphone.
(2). Instrument/Microphone 2 Input with Level Control (1/4”):
This mono input accepts a 1/4” input such as a microphone, guitar, or other musical inst rument.
(3). CD/Tape input with Level Control (Stereo RCA):
This knob controls the level of the CD and the RCA input. This stereo RCA input can be
used to connect a CD, MP3, or other audio source. To connect to a portable device with
a 1/8” headphone jack, you need a standard (1/8” to RCA) adapter which is NOT included.
(4). EQUALIZATION CONTROL(EQUALIZATION)
This is a 3-band equalizer that allows you to adjust the frequency response of the MAIN
bus signal.
(5). Master Volume Control:
This knob controls the master volume of the system.
(6). MP3 player
It has two input mode, USB and SD input. LCD display for the correspond input.
(7). Power Adapter (IEC)
Insert the included power cable here to charge the unit. Note that the system can run off
the power adapter while it simultaneously charges the battery. The charge indicator illum inates when the battery is charging.
(8). Power Switch:
Turns this apparatus ON/OFF.
(2)
(3)
Page 4
(9). Link Output:
This 1/4” jack can be connected to the system input of an amplifier or amplified loudspeaker
such as another system.
(10). Battery level indicator:
while the unit is powered ON, these four lights indicate the power left in the battery. Battery
life varies based on volume and usage.
5. CONNECTION EXAMPLES
Important: with all large speakers, an initial “break-in” period is needed to perform at optimal
levels. To properly “break-in” your system, play an audio source at medium volume for a few
hours.
1. IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
To reduce the risk of electric shock, do not remove
No user serviceable parts inside; refer servicing to qualified personnel.
the top cover (or the rear section).
CHARGE
ON
POWER INPUT
AC 230V 50 /60Hz
T0.5A/250V
OFF
POWER
OUTPUT
H 3
C
2
H
C
CH 1
USB
R
SD
L
IN
CD/TAPE
IN/MIC 2 IN
MIC 1 IN
UNBAL
BAL
TREBLE
GAIN
GAIN
GAIN
0
+15
51
0
10
0
10 10
0
LINK
MIDDLE
51 +15
USB/SD DIGITAL PLAYER
V+V-
BASS
0
0
5110
+15
C H 1 C H 2 C H 3
MIC 1 IN
BAL
INS/MIC 2 IN
UNBAL
OR
EQ
USB/SD
POWER
MASTER VOL
0
CD/TAPE IN
L
3
2
1
LOW
SOUND SYSTEM
BATTERY LEVEL
USB
R
L
SD
R
Cable sold separately
To other AMP
L
R
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain and
moisture.
This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous
voltage inside the enclosure-voltage that may be sufficient to constitute a risk of shock.
This symbol, wherever it appears, alerts you to
important operating and maintenance
instructions in the accompanying literature. Please read the manual.
2. DETAILED SAFETY INSTRUCTIONS:
(1) Re ad the se ins truct ions.
(2) Ke ep the se ins truct ions.
(3) He ed all warni ngs.
(4) Fo llow a ll ins truct ions.
(5) Do not us e this devic e near water.
(6) Cl ean on ly wit h a dry cloth .
(7) Do not block any ventilation openings. Install in accordance with the manufacturer s instructions.
(8) Do not install near any heat sources such as radiators, heat registers, stoves, or other app aratus (including amplifiers) that produce heat.
1
8
6
2
4
3
5
7
9
1
0
TONE
VOLUME
4
2
1
8
6
3
5
7
9
0
1
TONE
4
2
1
8
6
1
3
5
7
9
0
(9) Do no t defeat the s afety pu rpose of the polarized or grounding-type plug . A polarized plug
has two blades with o ne wider than the other. A grounding type plug has tw o blades and a
third g rounding prong. The wide blade or the third pron g are provided for you r safety. If the
provided plug d oes not fit in to your outlet, consult an electricia n for replacemen t of t he ob solete outlet.
(1)(4)
Loading...