SoundOn WHP-i230 Quick Start Manual
1
WHP-210
1.Charge Headphone 3.5 hours.
2.Connect Transmitter to i-Pod.
3.Turn on Headphone and i-Pod.
4.Wearing the Headphones, hold down the LINK buttons
on both the Headphone and the Transmitter until a beep
is heard indicating the device are link.
5.Enjoy your wireless experience
WHP-i230
Quick Start
2
WHP-i230:
Wireless Music Anywhere
SoundOn’s WHP-i230 is the world’s fi rst 2.1
wireless headphone with a portable i-Pod transmitter allowing you to go virtually anywhere with
your music, but without the wires. Point-one
technology takes the traditional headphone with
two speaker-drives and enhances the performance with the addition of a built-in sub woofer.
Point-one technology allows the listener to invite
all the low-emission bass sounds life co-exists
with.
All of SoundOn’s wireless headphones use
Adaptive Frequency Hopping technology ensuring the headphone is always searching for, fi nd-
ing, and moving to the clearest channel available. The result is the clearest wireless sound
available, which Bluetooth’s “blind hopping” and
other wireless technologies cannot achieve.
3
Unique Features
Based on advanced WiStereoTM digital wireless technology for reliable transmission of
music in the 2.4 GHz band.
Effective within 30 feet range from source.
Patented dual-speakers in each of the ear-
cups delivering a full range of sounds as well
as a soft, deep bass.
The transmitter can be powered by the i-Pod
adapter.
Extended battery life lasts up to 12 hours
when fully charged.
Ultra comfortable headband design for long
wear hours.
4
Parts Introduction
Length
adjustment
LED Indicator
Power On/Off
Charging Port
Reset
1
2
3
4
5
6
7
90
0
1
2
3
4
5
6
7
90
0
LINK
Next track
Previous track
5
Next track
Skip to next song.
Previous track
Skip to previous song.
LED Indicator
A red indicator represents charging functions.
A blue indicator represents signal connections.
LINK
Press “LINK” button to connect the wireless
headphone and the iPod transmitter.
Power On/Off
Press this button to control power on/off.
Charging Port
Connect to the AC power adapter for charging.
Reset
If headphone is functioning improperly,
poke the reset hole by a paper clip.
1
2
3
4
5
6
7
6
Getting Started
Charging
AC Power adapter
First time use :
Charge 3.5 hours before using headphone for
the fi rst time.
Plug in to charge Unplug when fi nished
The headphone is charging.
Steady red light is turned off when the headphone is fully charged.
To ensure this headphone to work properly,
please avoid recharging while using.
AC Power Adapter is used to both charge the
headphone and the transmitter( if batteries
are not powering the transmitter).
Charging the Headphone
Loading...