SoundOff Signal 600 User Manual

600 SERIES SWITCH PANEL
INSTALLATION INSTRUCTIONS

ETSP6F

REPLACEABLE LEGENDS

OPERATION:

Switches are sequential from left to right on
front panel. Note that switch 1 is 40A (inter­nal) and switches 2-6 are 20A fused.

SAFETY NOTICE:

The outputs of the switch panel are protect­ed with a 40 Amp thermal breaker on main
input and individual fuses on the outputs.
Make sure to only replace with same type
and rating of fuse.

Make sure to properly fuse the supply wire
at the source of power in the event of a
short circuit. Also make sure the wire gauge
is sufficient to carry a minimum of 50 Amps
of current.

INSTALLATION:

Immediately after unpacking, examine the
switch panel for any damage that may have
occurred during transit. If the equipment
has been damaged during transit, promptly
file a claim with the carrier. Carefully check
all envelopes, shipping labels, and tags
before removing or destroying them.

MOUNTING YOUR SWITCH PANEL:

This switching system comes with a

Universal Bail Bracket that allows for

versatile mounting in position needed.

Positioning the bracket below the unit
permits it to be mounted on a horizontal

surface. Positioning the bracket above

the unit permits it to be mounted to the
underside of the dash.

1 2 3 4 5 6

SW 1 (INTERNAL 40A)
SW 2-6 (20A)

Important Information:

• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.

FUNCTION WIRE COLOR LABEL GAUGE

Switch 1 Red 12
Switch 2 Blue 14
Switch 3 Gray 14
Switch 4 Yellow 14
Switch 5 Orange 14
Switch 6 Green 14
Main Power Red “H” 8
Ground Black “G” 18
Backlight Red “B” 18

Determine where you will locate the unit
then use the mounting bracket as a guide

and drill holes into the mounting surface

using the appropriate size drill bit.

The bracket can then be mounted to the
surface. The type of hardware will vary
depending on what surface the switch panel

is being mounted to.

SAFETY NOTICE:

When drilling into the vehicle, ensure

that both sides of the surface are clear of

anything that could be damaged.

DIMENSIONS

Overall

Dimensions:

6.2”L x 5.2”W x

2.2”D

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns”

link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to

skip the automated message. Questions or comments that do not require immediate attention may be emailed to [e-mail].

1.800.338.7337. / www.soundoffsignal.com / Thank you for trusting us with your safety!

ETSP6F 2.14