SoundOff Signal 3000 User Manual

Stainless Steel Brush Guard

BEFORE ATTEMPTING INSTALLATION,
BE SURE YOU FULLY READ AND
UNDERSTAND ALL INSTRUCTIONS.

TO MOUNT THE 4" OR 6" BRUSH GUARD:

6" BRUSH GUARD (E360BG6)

4" BRUSH GUARD (E360BG4)

CLEAR DOME (CONFORMS TO
CALIF. TITLE XIII REQUIREMENTS)

E360BG(x)

6" BRUSH GUARD SHOWN

INSTALLED OVER 6" BEACON

AND CLEAR DOME

1) Remove the 1/2" screws holding the lens in
place.

2) Place the brush guard over the lens using either
the dress ring or the clear dome as a spacer.
Note: the 6" brush guard must be used with the
clear dome and either the 4" or 6" guard may be
used with the dress ring.

3) Secure the brush guard with the 3/4" screws
supplied. DO NOT OVERTIGHTEN! as this may
damage the beacon or brush guard.

REMOVE 1/2" SCREWS AND
REPLACE WITH THE 3/4"
SCREWS SUPPLIED.

DRESS RING

1/2" SCREW
(REMOVE)

3/4" SCREW
(INSTALL)

E360BG(x) 3/05