DEUTSCH
PORTUGUÊS
ENGLISH
ESPANOL
FRANÇAIS
SLOVENSKÝ
NEDERLANDS
ČEŠTINA
PL525
Hersteller
Wörlein GmbH Tel.: +49 9103/71670
Gewerbestrasse 12 Fax.: +49 9103/716712
D 90556 Cadolzburg Email. info@woerlein.com
GERMANY Web: www.woerlein.com
Safety, Environmental and Setup Instructions
EN
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household
waste at the end of its life cycle. Return it to a collection
point for the recycling of electrical and electronic devices.
This is indicated by the symbol on the product, user
manual or packaging
The materials are reusable according to their markings. By
reusing, recycling or other forms of utilization of old devices you
make an important contribution to the protection of our
environment.
Please contact your local authorities for details about collection
points.
WARNING
Risk of electric shock
Do not open!
Caution: To reduce the risk of electric shock, do not remove the
cover (or back). There are no user serviceable parts inside.
Refer servicing to qualified service personnel.
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the device
Used batteries are hazardous waste and NOT to be
disposed of with the household waste! As a
consumer you are legally obligated to return all
batteries for environmentally responsible recycling –
no matter whether or not the batteries contain harmful
substances*)
Return batteries free of charge to public collection points in your
community or shops selling batteries of the respective kind.
Only return fully discharged batteries
*) marked Cd = cadmium, Hg = mercury, Pb = lead
Only use mercury and cadmium-free batteries.
Used batteries are hazardous waste and NOT to be
disposed of with the household waste!!!
Keep batteries away from children. Children might swallow
batteries.
Contact a physician immediately if a battery was swallowed.
Check your batteries regularly to avoid battery leakage.
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly
replaced
Replace only with the same or equivalent type
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product
and keep it away from children.
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
To prevent possible hearing damage, do not
listen at high volume levels for long periods
Use the device in dry indoor environments only.
Protect the device from humidity.
This apparatus is for moderate climates areas use, not
suitable for use in tropical climates countries.
No objects filled with liquids, such as vases, shall be
placed on the apparatus.
The mains plug or an appliance coupler is used as the
disconnect device, the disconnect devices shall remain
readily operable.
Connect this device to a properly installed and earthed
wall outlet only. Make sure the mains voltage
corresponds with the specifications on the rating plate.
Make sure the mains cable stays dry during operation.
Do not pinch or damage the mains cable in any way.
A damaged mains cable or plug must immediately be
replaced by an authorized service center.
In case of lightning, immediately disconnect the device
from the mains supply.
Children should be supervised by parents when using
the device.
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE
CLOTHS!
Do not expose the device to direct sunlight or other
heat sources.
Install the device at a location with sufficient ventilation
in order to prevent heat accumulation.
Do not cover the ventilation openings!
Install the device at a safe and vibration-free location.
Install the device as far away as possible from
computers and microwave units; otherwise radio
reception may be disturbed.
Do not open or repair the enclosure. It is not safe to do
so and will void your warranty. Repairs only by
authorized service/ customer center.
No naked flame sources, such as lighted candles,
should be placed on the unit.
When you are necessary to ship the unit store it in its
original package. Save the package for this purpose.
In case of malfunction due to electrostatic discharge or
fast transient (burst), remove and reconnect the power
supply.
If the unit is not using for a long period of time,
disconnect it from the power supply by unplugging the
power plug. This is to avoid the risk of fire.
PL525 / English Instruction Manual
1
REMOTE CONTROL
Battery replacement
The battery compartment is located on the back of the remote control.
1. Remove the battery compartment door by pressing in on the tab and lifting it off.
2. Insert one (1) CR2032 size batteries into the battery compartment following the polarity
markings inside the battery compartment.
3. Replace the battery compartment door.
Button description
1. FUNC“
Press to select the functions
(Phono/USB/Aux/Radio)
2. On/Standby
Press to switch on/standby the
system
3. Skip up
/ down
Select next / previous track
Tuning up / down in Radio mode
4. FOLDER/PRESET
▲/ ▼
Press to skip up/down the album
Press to up / down Preset
5. REP/INTRO/RAN
Press to active repeat /intro/
random function for USB playback
6. DISPLAY
Press to display difference
information of the system
7.
In encoding mode : press to active
track separation function
8. VOLUME -/+
Press to adjust volume level up/
down
9. REC
Press to encode the tracks in the
MP3 format
10. Play/pause
ST / MONO
Press once to start USB playback. Press once again to pause play
temporarily
11. Stop
In USB mode : press to terminate playback or cancel programmed
memory.
12. INFO/DELETE
In MP3 playback mode : press to active ID3 function
In USB mode : press to active file delete function
13. MEN/CLK-ADJ
In USB mode : press to active tracks program function
In standby mode : press to adjust clock
14. SLEEP/TIMER
In on mode : press to active sleep function
In standby mode : press to set the alarm on/off time and active/deactive alarm function
15. EQ
Press to select different EQ mode
PL525 / English Instruction Manual
2
LOCATIONS OF CONTROLS
1. Dust cover
2. Stop button
3. EQ button
4. Function knob
5. Skip down button
6. Record button
7. LCD display
8. Remote sensor
9. Play/Pause /ST/MONO button
10. Skip up button
11. Folder PRE ▲
12. On-Off / Volume knob
13. USB socket
14. 3.5 mm aux-in jack
15. 3.5 mm headphone jack
16. MEM/CLK-ADJ button
17. Spindle adaptor
18. Tone Arm Lifting Selector
19. Turntable speed selector
20. Auto stop switch
21. Pick-up holder
22. Tone Arm
23. Line out socket
24. AC line cord
Caution:
Usage of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
This unit should not be adjusted or repaired by anyone except qualified service personnel.
Installation
Unpack all parts and remove protective material.
Do not connect the unit to the mains before checking the main voltage and before all other
connections have been made.
Do not cover any vents and make sure that there is a space of several centimeters around
the unit for ventilation.
Connection
1. Connect the power cord (24) to AC outlet
2. When you first plug the unit into the mains, the LCD display (7) will show “ 0 : 00 ”.
3. Turn on the unit by “ON/OFF/Volume” knob (12), if the LCD display (7) is on with
backlighting, it means the power supply is normal. Now your system is ready to play the
music.
Loading...