SOUNDMASTER DAB450 User Manual

DEUTSCH

NORSK

ENGLISH

SVENSKA

FRANÇAIS

DANSK

NEDERLANDS

ČEŠTINA

ITALANIO

DAB450

Hersteller

Wörlein GmbH Tel.: [phone]
Gewerbestrasse 12 Fax.: [phone]
D 90556 Cadolzburg Email. [e-mail]
GERMANY Web: www.woerlein.com

ENVIRONMENTAL PROTEC

TION

Do not dispose of this product with the normal household waste at the end

Do not open

!

of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.

The materials are reusable according to their markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.

Please contact your local authorities for details about collection points.

WARNING

Risk of electric shock

Caution: To reduce the risk of electric shock, do not remove the

cover (or back). There are no user serviceable parts inside. Refer

servicing to qualified service personnel.

This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.

This symbol indicates the presence of important
operating and maintenance instructions for the
device.

Safety, Environmental and Setup Instructions

• Use the device in dry indoor environments only.

• Protect the device from humidity.

• Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.

• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with

the specifications on the rating plate.

• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.

• A damaged mains cable or plug must immediately be replaced by an authorized service center.

• In case of lightning, immediately disconnect the device from the mains supply.

• Children should be supervised by parents when using the device.

• Clean the device with a dry cloth only.

Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!

• Do not expose the device to direct sunlight or other heat sources.

• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.

• Do not cover the ventilation openings!

• Install the device at a safe and vibration-free location.

• Install the device as far away as possible from computers and microwave units; otherwise radio reception may be

disturbed.

• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized
service/ customer center.

• Only use mercury and cadmium-free batteries.

• Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!

Return the batteries to your dealer or to collection points in your community.

• Keep batteries away from children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.

• Check your batteries regularly to avoid battery leakage.

• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

• CAUTION: Danger of explosion if battery is incorrectly replaced

Replace only with the same or equivalent type

DAB450 / English Instruction Manual

Carry handle

Battery compartment

Telescopic aerial

Speaker

Rotary FM tune control

DC socket 5V

Stereo headphone socket

Standby

Scan

Previous

Backlit Display

Preset

Menu

Info

DAB / FM

Select

On /Off wheel

Next

Volume control

Alarm

Info

LOCATIONS OF CONTROLS

Front view Rear view

Top view

CONNECT TO POWER

Setting up

1. Connect the mains power lead into the socket on the back of the radio and fully extend the radio aerial
in a vertical position to obtain the maximum signal strength.

2. Plug the power adaptor into the mains power wall socket.

3. Rotate ‘On/Off’ wheel on the top of the radio to turn on the radio. Press and release the ‘Standby’
button on the top of the radio. Your radio will switch on and begin an automatic scan for DAB radio
stations. A progress bar will show the progress of the scan and the number of stations found during the
scan will also be displayed. When the scan is complete your radio will select the first available station
and begin to play.

Note: The DAB radio station list is stored in the memory and so the next time you switch your radio on, the
station search does not take place.

1