Sound Magic Neo Dynamic Operational Manual

Sound Magic Neo Dynamic – New Time for Dynamic Processing!

Neo Dynamic

New Time for Dynamic Processing

Developed by

Sound Magic Neo Dynamic – New Time for Dynamic Processing!

Operational Manual

The information in this document is subject to change without

notice and does not present a commitment by Sound Magic Co. Ltd.

The software described in this document is subject to a License

Agreement and may not be copied to other media. No part of this

publication may be copied, reproduced or recorded, for any purpose,

without prior written permission by Sound Magic Co. Ltd. All

product and company names are trademarks of their respective

owners.

Sound Magic Co. Ltd

http://www.supremepiano.com

http://www.soundemon.com

[e-mail]

[e-mail]

206, Min 4, People Daily, ChaoYang, Beijing

P.R.China

Version 1.0

Sound Magic Neo Dynamic – New Time for Dynamic Processing!

Register Neo Dynamic

Neo Dynamic must be registered before it could sound.
You have to enter keycode into the text box.
First, please find the text box named Enter Your KeyCode Here

Then paste the keycode into the box

Press Enter, you will see Authorized to XXXXXXXX

If the text box still shows the keycode, it means the keycode is not correct, You
need to contact customer service to get a new keycode. Please note 95% of
the failures are caused by copy one more space at the beginning or the end of
the keycode.

What if YOU enter the keycode incorrectly?
The only solution for this problem is for the customer to delete the Windows
Registry Entry.
Click "Start" on the windows desktop.
Click "Run" and type in 'regedit' then press enter. A window will appear.
Click the 'Edit' tab and select 'Find..." and type in “NEOMIXING "then press
enter.
Right click on the folder highlighted in the Left window and select 'Delete' and
click 'Yes' to confirm to delete this item.
Close the window.

Load the VST and it should show " *Enter Your KeyCode Here * "
If it does not show this message you should follow the above procedure again
taking care to follow every step.

Sound Magic Neo Dynamic – New Time for Dynamic Processing!

Controls

Threshold: in dB, ranging from 0dB to -40dB.

Gain: Boost in dB, ranging from -6dB to 24dB

Ratio: Ranging from 1:1 to 12:1, Please Note when you put it into
Maximum(12:1) position, It will auto switch to limiter mode.

Attack: Attack Time in ms, ranging from 0ms to 100ms.

Release: Release Time in ms, ranging from 0ms to 2000ms (2 Seconds).

Soft Knee: When turn it on, it is soft knee. When off, it will be hard knee

AGC: Turn on Auto Gain Control Mode.

Auto Release: Turn on Auto Release Mode

Look Forward: When turns it on, There will be <2ms (50 samples) delay for

main signal. Then the dynamic processors will have look forward function.

Sensor Network:

Sensors will tell you below things:
Tell you whether you threshold setting is too high to make the
compressors/limiters actually not working.
Tell you whether you compress too hard so that Over-Compression happens.
But sometimes, over-compression is good for some styles of music
Tell you the compressors/limiters’ distortion rate. This is common determined
by attack and release values.