Soundgraph SG24G, SGLT Users Manual
iMON & Multi-Median
Users Guide
(Draft)
z
SoundGraph, Inc.
Table of Contents
In your Package 4
1. iMON 2.4G LT 4
2. iMON 2.4G DT 4
S/W, H/W Installation and Remote Controller 5
1. Installation Process 5
1) S/W Installation 5
2) H/W (RF Receiver) Installation 5
3) Execute iMON Manager 7
2. Button Layout and its Feature of iMON Remote Controller 8
1) iMON 2.4G Remote Controller 8
Multi-Median Users Guide 18
1. Screen Layout of ‘Multi-Median’ 18
1) Main View 18
2) Hard Disk Drive 19
3) Media Folder View 20
4) Media File View 20
5) Media Preview 21
6) Full Screen View 22
7) DVD View 22
8) TV View 22
9) Digital Camcoder View 22
2. Using Remote Controller on Multi-Median 23
3. Using Mouse on Multi-Median 25
4. Setting Environment 26
1) Back 26
2) Scan Media 26
3) Music 26
4) Movie 26
5) Photo 27
6) TV 27
7) DVD 27
8) Digital Camcoder 27
5. Installation of Video Codec 27
-2-
iMON Users Guide 29
1. Using Application Launcher 29
2. Using Task Switcher 29
3. Application Control 30
4. Using All Time Control Mode 30
5. Using Monitor Resolution Changer 31
6. Using Timer 31
7. Using Virtual Kyboard 32
8. Register New Remote Controller 33
9. Setting Program Command 33
10. Setting Windows Command 34
11. Setting Customized Windows Command 34
12. Setting Macro 35
13. Setting Option 35
Update of iMON & Multi-Median 37
SoundGraph, Inc. 38
-3-
This device complies with Part15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operations.
INFORMATION TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver
-Correct the equipment into an outlet on a circuit different from that to which
The receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
WARNING (Part 15.21)
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
“Note: The manufacturer is not responsible for any Radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.”
-4-
In your Package
iMON product lineup is divided into four different models according to
the RF remote controller and RF receiver. Each product is composed as
like follows. Please check the components on the below in your box.
1. iMON 2.4G LT
In the Box : 1 iMON 2.4G Remote Controller, 1 iMON 2.4G LT (External RF Receiver), 1
Installation CD (iMON Manager, Multi-Median), 2 AAA Batteries, 1 Users Guide
Specification of Remote controller
Operation range : 30m
Battery : 1.5V AAA type
Specification of External Receiver
OS : Windows 98, 98 Se, Me
Windows 2000, Windows XP
System Recommendation : Pentium III or higher, 256 Mb of higher
USB 1.1 compatibility
z
2. iMON 2.4G DT
In the Box : 1 iMON 2.4G Remote Controller, 1 iMON 2.4G DT (Internal RF Receiver), 1
Installation CD (iMON Manager, Multi-Median), 2 AAA Batteries, 1 low profile bracket, 1 usb
-5-
cable, 1 Users Guide
Specification of Remote controller
Operation range : 30m
Battery : 1.5V AAA type
Specification of Ixternal Receiver
OS : Windows 98, 98 Se, Me
Windows 2000, Windows XP
System Recommendation : Pentium III or higher, 256 Mb of higher
Mounted on PCI port
USB 1.1 compatibility
z
S/W, H/W Installation
and Remote Controller
Please read this users guide before the installation of your iMON
Station (IR Receiver).
1. Installation Process
1) S/W Installation
-6-
Insert iMON&Multi-Median Installation CD to your CD ROM, and install the iMON Manager and
Multi-Median according to the auto running S/W installation process.
2) H/W (RF Receiver) Installation
① External iMON 2.4G LT Installation
Connect your External iMON Station to your USB port, then assign the H/W driver according to
the ‘Found New H/W Wizard’. Assign the CD ROM drive for searching H/W driver.
② Internal iMON 2.4G DT Installation
Internal iMON 2.4G DT can be loaded to the 3.5” floppy drive bay. The additional feature of
internal type iMON 2.4G DT is that you could power on your PC system using the power button
of the remote controller. After turn off your PC system, open your PC case and connect the
cable to its proper pin refer to the following picture.
-7-
Internal iMON 2,4G DT is connected to mainboard with two cables, PC case with one cable,
Power Supply with one another cable. You should be careful to connect these four cables refer
to your mainboard manual. The connectors that each cable needs to be connected are as like
follows.
-8-
1. Stand-By Power Connection Cable
A1 : (2pin, iMON Inside ‘ST PWR1’
A2 : (2pin, Mainboard power extension cable)
connector)
2. Mainboard Power Switch Connection Cable
B1 : (2pin, iMON Inside ‘M/B PWR’
connector)
B2 : (2pin, Mainboard power switch
connector)
3. PC Case Power Switch Connection Cable
C1 : (2pin, iMON Inside ‘PWR S/W’
C2 : (2pin, PC Case power switch connector)
connector)
4. Mainboard USB Connection Cable
D1 : (5pin, iMON Inside USB connector) D2 : (4pin, Mainboard USB internal connector)
The names of the additional USB port pins on the mainboard manual are different with the
manufacturer. Please refer to the following table to connect the USB cable.
Line Color Additional USB Port Pin Name
RED VCC, POWER, USBPOWER
WHITE D-, DATA-, USBP#-, UP#-, P#GREEN D+, DATA+, USBP#+, UP#+, P#+
BALCK GND, GROUND
After all the connection finished, turn on your system. You may see the ‘Found New H/W
Wizard’ when Windows starts. Assign the CD ROM drive for searching H/W driver like the
external USB iMON station setup process.
3) Execute iMON Manager
After finish the S/W and H/W installation, please execute the iMON Manager using the desktop
iMON icon. Please refer to the iMON Users Guide in order to learn about the various settings
and usage of iMON Manager.
-9-
2. Button Layout and its Feature of iMON Remote
Controller
1) iMON 2.4G Remote Controller
iMON 2.4G remote controller is designed in order to use every functions of Multi-Median. The
detail features of each button are as like follows.
Power : This button is used to turn on or turn off the PC. You need to push this
button more than 2 seconds in order to turn off the PC.
The Power ON feature is supported on the internal type iMON Station
model, iMON Inside, iMON Inside PLUS only.
App. Exit : This button generates the keyboard short cut, [ALT]+[F4], which is
used for closing the active window.
Num 0~9 : The numeric buttons from 0 to 9 are custom buttons that could be
assigned by users. These buttons act as a shortcut of the media view on the
Multi-Median application as printed like below the button.
-10-
Please refer to the Multi-Median Users Guide in order to learn about
the button usage on the Multi-Median.
Windows : This button brings the start menu and acts like the [Windows logo]
key of the keyboard.
Menu : This button brings the menu and acts like the [menu] key of the
keyboard.
App. Launcher : This button runs the Application Launcher which could execute
many assigned windows applications.
Task Switcher : This button is used for choosing the application among the
current running applications. This feature is similar to the [ALT]+[TAB] keyboard
command.
Multi-Median : This button runs the Multi-Median which is provided with the
iMON Manager. You could enjoy the various media files like DVD, Movie, Music,
Photo and use the multimedia device like TV card, Digital Camcoder, and Digital
Camera.
ESC/Back : This button is used as same like [ESC] key of the keyboard.
Select : This button is used as same like [Spacebar] key of the keyboard.
-11-
Up, Down, Left, Right : These buttons are used as same like four way arrow
keys of the keyboard.
Enter : This button is used as same like [Enter] key of the keyboard.
All Time Control Mode : This button used for the ‘All Time Control Mode’ of the
iMON Manager. Please refer to the iMON Users Guide for the details of the ‘All
Time Control Mode’.
Eject : This button is used to open and close the CD/DVD ROM.
VOL - : This button is used to reduce the PC system volume.
VOL + : This button is used to increase the PC system volume.
MUTE : This button is used to mute the PC system volume.
Play : This button is used to generate ‘Play’ command in the various media
applications.
Pause : This button is used to generate ‘Pause’ command in the various media
applications.
-12-
Loading...