SoundFreaq SFQ-06 User Manual

Sound Platform 2

Playback via Bluetooth

PAIR Bu tton

Pair Indicator

1. Press the POWER ( ) button to turn on Sound Platform

2. Press the SOURCE button on the unit or remote control to
toggle sources and to select Bluetooth mode.

3. Press the PA IR but ton on the unit to place it in pair mode.
Once in pair mode the pair indicator will flash rapidly.

Note: The pair indicator turns solid after the device is

successfully connected.

4. Open the Bluetooth settings menu on your Bluetooth
enabled mobile device or computer. Once the unit is
recognized, “Sound Platform 2” will appear on the list of
detected devices. Select “Sound Platform 2” to pair with
your device. On Apple iOS devices, select Settings >
General > Bluetooth and tap “Sound Platform 2” from the
device list. Note: For detailed instructions to pair Mac or
Windows PC, please refer to online support.

POWER But ton

Soundfreaq App

We offer a Soundfreaq App to use as a remote control for
Sound Platform 2. Visit the iTunes App Store or Google Play.

AUX IN J ack

Connect any device with headphone or line out jack with
a 3.5mm line in cable into the AUX IN Jack. Press the

SOURCE button to cycle through input options to select
Aux input.

Listening to the Radio

FM AN T Jack

1. Press the POWER ( ) button to turn on Sound Platform

2. Press the SOURCE button on the unit or remote control to
toggle sources to select FM Radio mode.

3. Press the button and but ton on Sound Platform 2 to
tune to the desired FM radio station.

Note: Use the included FM ANT for better reception.

USB Po wer Ports

The USB power jack can be used to charge most devices
that allow for USB charging (including many mobile
phones, smart phones and wireless headsets). Note:
Please use the USB power cord that came with your
device to connect to Sound Platform 2 to charge.

The Universal Device Tray slides out to hold a phone or
tablet while streaming or charging. Press the front of the
Universal Device Stand to open. To neatly stow cables,
use the Finger Notch to open the Door on the back of
Sound Platform 2. Cables can be routed from the back to
the front of the Universal Device Tray and held in place
with the Cable Clip.

Finger Notch

Door Cable Clip

Universal Device Stand

Optimizing Sound QualityPlayback via AUX Charging an External Device

™

is a proprietary technology that enhances stereo
separation. To turn UQ3 on/off press the button.

Press TONE button to select a bright, warm or neutral tone
for your listening preference.

TIP: Sound Platform has been tuned to a balanced acoustic

profile. You can use the EQ settings on your playback device
to further customize the EQ balance to suit your personal
preference. Note: Some custom EQ settings when combined
with UQ3 enhancement may cause distortion.

Tip: For playback in Bluetooth or Aux mode, the output

volume is set by both the volume control on Sound Platform
2 and the source device. Both may be adjusted to set your
preferred listening volume. Typically, sound quality is best
when the volume of the source device is between 70-90%.

Note: A s with any speaker system, if the volume on both

your source device and the speaker are at maximum output,
it is possible to overdrive the speakers and cause distortion.
When using an iOS device or other device that offer s a
"volume limit" feature, turn this setting off for higher
volume listening in Bluetooth or Aux mode.

For safety, care and additional operating instructions please
download the User Manual at www.soundfreaq.com.

For further assistance with setting up Sound Platform 2,
we are available at:

[e-mail]

soundfreaq.com/support