SoundFreaq SFQ-01 User Manual

The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (ser vicing) instructions in the
literature accompanying the appliance.

Safety Information

WARNINGS:

.1.

The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

DO NOT REMOVE COVER or OPEN THE CABINET.

Dangerous high voltages are present inside the enclosure.
No user servicea ble parts i nside. Leave all ser vicing to
qualified service personnel.

10. Protect the power cord from being walked
on or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the apparatus.

11. Only use attachments/accessories specified
by the manufacturer.

12. Use only with the cart, stand, tripod, bracket
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.

14. Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is damaged,
liquid has be e n s p illed or obj e c t s have
fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not
operate normally, or has been dropped.

15. Apparatus shall not be exposed to dripping
or splashing and no objects filled with liquids,
shall not be placed on the apparatus.

16. The mains plug is used as disconnect device
and it shall remain readily operable during
intended use. In order to disconnect the
mains plug from the mains completely, the
mains plug should be disconnected from
the mains socket outlet completely.

17. The batteries (battery pack & batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these Instructions.

3. Heed all Warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install
in accordance with the manufacturer's
instructions.

8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.

9. Do not defeat the safety purpose of the
polarized or grounding - type plug. A polarized
plug has two blades with one wider than
the other. A grounding type plug has two
blades and a third grounding prong. The
wide blade or the third prong is provided for
your safety. If the provided plug does not fit
into your outlet, consult an electrician for
replacement of the obsolete outlet.

PORTABLE CART WARNING

(Symbol provided by RETAC)

.2.

For compatibility between the SFQ-01 system
and another device with Bluetooth technology,
consult the device's documentation and dealer.
In some countries, there may be restrictions on
using Bluetooth devices. Check with your local
authorities.

Bluetooth is a registered trademark of Bluetooth
SIG, Inc

Please read rating label at the bottom of system
for power input and other safety information.

FCC and IC Information:

This device complies with Part 15 of the FCC
Rules and RSS-210 of the IC Rules. Operation is
subject to the following two conditions: (1) This
device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.

Warning: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.

Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment

and receiver.

 Connect the equipment into an outlet on a circuit

different from that to which the receiver is
connected.

 Consult the dealer or an experienced radio TV

technician for help.

Warnings: The device meets the exemption
from the routine evaluation limits in section 2.5
of RSS 102 and users can obtain Canadian
information on RF exposure and compliance
from the Canadian Representative Burnport
Holdings Ltd. 72MT Belcher Pls, East, Calgary,
Alberta, T2Z 2G1, CANADA. Tel: [phone]

FCC&IC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment and meets the exemption from
the routine evaluation limits in section 2.5 of
RSS 102.

1. This Transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.

2. This equipment complies with FCC RF
radiation exposure limits set forth for an
uncontrolled environment. This equipment
should be installed and operated with a
minimum distance of 20 centimeters from
user and bystanders.

.3.

CAUTION - Proper Ventilation

To avoid risk of electric shock and fire, and to
prevent damage, locate the apparatus as
follows:

Front: No obstructions and open spacing.

Sides / Top / Back: No obstructions should be

placed in the areas shown by the dimensions
below.

Bottom: Place on the level surface. Maintain an
adequate air path for ventilation by placing on a
stand with a height of 10 cm (3-15/16") or more.

15cm
(5-

15

/16")

15cm

(5-

15

/16")

15cm

(5-

15

/16")

Front View:

15cm
(5-

15

/16")

15cm

(5-

15

/16")

Side View:

10 cm

(3-

15

/16")

Front side Back side

QDID: B016948

CAUTION - Proper Installation

 Install the system in a place which is level, dry

and neither too hot nor too cold. The appropriate
temperature is between 5 oC and 35 oC.

 Install the system in a location with adequate

ventilation to prevent internal heat from
building up inside the unit.

 Leave sufficient distance between the system

and TV.

 Keep the system away from TV to avoid

interference with TV.

.4.

Getting Started

Package Contents

Installing/Replacing the Batteries

Connecting the AC Adapter

Using the Remote Control

System Overview

Front View

Back View

Remote Control

Selecting the Sound Source

Playing back from iPhone/iPod

Setting an iPhone/iPod on the Unit

Listening to an iPhone/iPod

Charging an iPhone/iPod

Playing back via Bluetooth/from iPad

Downloading the SoundFreaq App

Using multiple Bluetooth devices

Playing back from Macbook or Macbook Pro

Upgrading Wireless Connection Mode

Listening to Tuner

Listening to a Station

Presetting a Station

Playing back from External Source

Listening to the External Audio Device, Digital Music Player or

Any Other Audio Source

Activating "U-Cubed" Sound Effect

Troubleshooting

Technical Specifications

5

5

5

6

7

8

8

8

9

9

10

10

10

11

12

12

13

13

14

15

15

15

16

16

17

18

19

Contents

.5.

Package Contents

Examine whether the following package contents are all included :

Main Unit

Remote Control

FM AntennaAdapter Cable

Switch Power Adapter

Getting Started

+

C 20253VR

 It is loaded on the remote

control at the factory.

Dock Adapters(2)

 For iPhone 3G/3GS

and iPod Touch

Lithium Coin Battery

CR2025

Installing/Replacing the Batteries

CAUTION: Danger of explosion if battery is

incorrectly replaced. Replace only with the
same or equivalent type.

1. Squeeze and pull to release the battery cover
latch. You can remove the battery door with
your fingernails by using the spaces set back
in wall.

2. Match the polarity on the Lithium Cell with a
plus sign (+) on the battery tray.

3. Slide the tray with new batter y into the
battery compartment until you hear a click
sound.

1

2

Squeeze

Pull

+

C 20253VR

Handling the Remote Control

 To avoid possible failure, read the following

instructions and handle the remote control
properly.

 Do not drop or cause impact to the remote

control.

 Do not spill water or any liquid on the remote

control.

 Do not place the remote control on a wet

object.

 Do not place the remote control under the

direct sunlight or near sources of excessive
heat.

Note: If you are not going to use the remote
control for a long time, remove the battery to
avoid any damage that may be caused by
leakage and corrosion.

.6.

Warning - When Using the Battery

 Store the battery in a place where children

cannot reach. If a child accidentally swallows
the battery, consult a doctor immediately.

 Do not recharge, short circuit, disassemble,

heat the battery, or dispose the battery in
fire. Doing any of these things may cause the
battery to give off heat, crack, or start a fire.

 Do not leave the battery with other metallic

materials. Doing this may cause the battery
to give off heat, crack, or start a fire.

 When throwing away or saving the battery,

wrap it in tape and insulate; otherwise, the
battery may start to give off heat, crack, or
start a fire.

 Do not poke the battery with tweezers or

similar tools. Doing this may cause the
battery to give off heat, crack, or start a fire.

 Dispose of battery in the proper manner,

according to federal, state, and local
regulations.

 The batteries (battery pack or batteries

installed) shall not be exposed to excessive
heat source such as sunshine, fire or the like.

 This product contains a CR Coin Cell Lithium

Battery that contains Perchlorate Material, so
that special handling may apply.

1. Insert the switch power adapter into 18V DC
IN .

2. Insert one end of the adapter cable into the
end of the switch power adapter and the
other end into an electrical outlet only after
all other connections are completed.

Connecting the AC Adapter

WARNING! For optimal performance, use only

the supplied AC adapter.

 Ensure that power supply outlet matches with

the unit AC's input 100-240V~, 50/60Hz
before connection.