Sony XPSR321 User Manual

XP-SR321/XP-SR320

COMPACT DISC PLAYER

OPERATING INSTRUCTIONS

8B-HCD-901-01

010205AYG-O9

Printed in Indonesia

OWNER’S RECORD

For your convenience, record the model number and the serial number (you will find it on the bottom of your set) in the space provided below. Please refer to them when you contact your Aiw a dealer in case of difficulty .

Model No. Serial No.

Highlighted letters in the text of this manual correspond to the illustrations.

PRECAUTIONS

To maintain good performance

• Do not use the unit in places which are extremely hot, cold, dusty or humid. In particular, do not use or keep the unit in following places.

• in a high humidity area such as a bathroom

• near a heater

• in an area exposed to direct sunlight (e.g., inside a parked car, where it can

become extremely hot)

• near sources of strong magnetism, such as televisions, speakers, or magnets

• where there is a lot of movement or vibration, such as on a car dashboard or

an unstable shelf

• Do not open the battery compartment with wet hands.

• Wipe the unit thoroughly before inserting batteries and after use.

• Do not soak the unit in water.

For safety

• Do not attempt to disassemble the unit. Laser r a ys from the optical pic kup are dangerous to the eyes.

• Make sure that pins or other foreign object do not get inside the player.

• Take care not to drop the unit or subject it to strong shocks.

• To keep dust from the pickup lens , k eep the disc compartment lid closed after use. Never touch the lens.

•

If you hear no sound when playing a disc, DO NOT turn the volume up high because music could suddenly start at high volume. Turn the volume control to the lowest level bef ore starting playback and slowly turn it up to the desired le vel.

NOTE FOR USE IN THE U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Ho wev er , there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follo wing measures:

– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on circuit different from that to

which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

Note on listening with the headphones

• Listen at moderate volumes to avoid hearing damage.

• Do not wear the headphones while driving or cycling. It may create a traffic hazard.

• You should use extreme caution or temporarily discontinue use in potentially hazardous situations, such as walking, jogging, etc.

• Wear them properly; L is left, R is right.

Note on condensation

If the unit is suddenly moved from a cold place to a warm one, it may result in condensation on the pickup lens and malfunction or playback difficulties. Should this occur, leave the unit for a few hours, then try to playback again.

MAINTENANCE

To clean the lens → A

If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner. To remove dust or dry particles, first use a camera lens blower/brush a to b low a few times to loosen particles, then gently brush the lens b clean. Finish by blowing the lens again. To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially a vailab le.

Note

T ake care not to get too m uch solution on the swab , which could flo w into the unit and cause damage. Pressing too strongly with the swab could scratch or break the lens.

To clean the discs → B

Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case.

SPECIFICATIONS

Tracking system 3-beam laser Laser pickup Semiconductor laser D/A conversion 4-times oversampling digital filter + 1-bit DAC Frequency response 20 – 20,000 Hz Output PHONES/LINE OUT jack (stereo mini-jack) Frequency range AM: 530/531 kHz – 1,710/1,602 kHz

(10 kHz/9 kHz steps)

FM: 87.5 – 108 MHz

Maximum output 12 mW + 12 mW (16 ohms at 1 kHz)

500 mV (47 k ohms at 1 kHz)

Power supply DC 3 V using two size AA (LR6) alkaline

batteries DC 2.4 V using two commercially available (Ni-Cd 1.2 V 700 mAh) rechargeable batteries AC house current using the supplied AC adaptor

Maximum outside dimensions

134 (W) × 32.5 (H) × 141 (D) mm (excluding projecting parts and controls) (5 3/8 × 1 5/16 × 5 5/8 in.)

Weight Approx. 294 g (10.3 oz.) excluding batteries Accessories AC adaptor AC-D603 (1)

Stereo headphones (1) Carrying case (XP-SR321 only) (1)

AC adaptor AC-D603U Rated input: AC 120 V, 60 Hz The specifications and external appearance of this unit are subject to change

without notice.

Stereo headphones (1) Carrying case (XP-SR321 only) (1)

AC adaptor AC-D603U Rated input: AC 120 V, 60 Hz The specifications and external appearance of this unit are subject to change

without notice.

USING ON DRY CELL BATTERIES → C

1 Set the dial to the OPEN position to open the disc compartment, then

open the battery compartment.

2 Insert two size AA (LR6) alkaline batteries with the 0 and 9 marks

correctly aligned. After batteries insertion, c lose the battery compartment firmly.

3 Close the disc compartment tightly and set the dial to the LOCK position.

Battery replacement

The battery indicator in the display changes from to to according to the remaining power of the batteries. Replace the batteries when lights. If the unit remains in use after lights, “Lo-bAtt” appears and oper ation stops.

To maintain preset data

When replacing the batteries, the unit will retain the preset station frequencies for about 1 minute. To prevent the erasure of the memories, replace the batteries within 1 minute.

• Before replacing the batteries, turn off the power by pressing sSTOP/OFF/CHARGE.

• DO NOT press any keys while replacing the batteries, otherwise it will not retain preset data for 1 minute.

Battery life (using alkaline batteries LR6)

The setting of the E•A•S•S switch Battery life 48 Approx. 27 hours 12 or OFF Approx. 19 hours

Battery life may vary depending on conditions of use.

XP-SR321/SR320(AU)E 1

If the cover of the battery compartment comes off → D

Note

Close the battery compartment firmly, or the compact disc may be damaged.

Note on dry cell batteries

• Make sure that the 0 and 9 marks are correctly aligned.

• Do not mix the different types of batteries, or an old battery with a new one.

• To prevent the risk of electrolyte leakage or explosions, never recharge the batteries, apply heat to them, or take them apart.

• When not using the batteries, remove them to prevent needless battery wear.

• If liquid leaks from the batteries, wipe thoroughly to remove.

DC 5~6V

STOP/OFF

CHARGE

USING ON RECHARGEABLE BATTERIES → E

• Be sure to use size AA Ni-Cd 1.2 V 700 mAh rechargeab le batteries, which are commercially available.

• Be sure to read the instructions of the purchased rechargeable batteries before use.

• When using on rechargeable batteries for the first time, charge them until the battery indicator goes out.

• Before charging the batteries, close the disc compartment. Y ou cannot charge the batteries while it is opened.

1 Insert the rechargeable batteries with the 0 and 9 marks correctly

aligned.

2 Connect the AC adaptor.

Pull out the rubber cap before connecting the adaptor.

1 to DC 5 ~ 6 V jack 2 to a wall outlet

3 Keep sSTOP/OFF/CHARGE pressed for about 1 second to start charging.

“C-On” appears, and the battery indicator blinks. When charging is completed, “C-OFF” flashes a few times, and the battery indicator goes out. After charging, disconnect the AC adaptor .

Time to recharge the batteries

Recharge the batteries when lights. If the unit remains in use after lights, “Lo-bAtt” appears and the current operation stops.

To stop charging

Press sSTOP/OFF/CHARGE during charging.

DSL

VOLUME

STOP/OFF

CHARGE

PLAY/PAUSE

PLAY MODE

PLAY/PAUSE

Force charging

When the recharging stops after only few minutes or the batteries cannot be fully recharged, press sSTOP/OFF/CHARGE while pressing PLAY MODE to start force charging.

ATTENTION:

The product you have purchased can be powered by nickel cadmium batteries which are recyclable. At the end of their useful life, under various state and local laws, it is illegal to dispose of these batteries into your municipal waste stream. Please call 1-800-289-2492 for information on how to recycle these batteries.

USING ON AC HOUSE CURRENT

Connect the supplied AC adaptor in the same way as when recharging the batteries. During operation on AC house current, all of the battery indicator disappears.

BEFORE PLAYBACK

HOLD switch → F

Release the HOLD switch before playback. → a When not using the unit, set the HOLD switch to the HOLD position. → b Accidentally pressed button will not function. If buttons are pressed when the HOLD switch is set to the HOLD position, “HOLd” flashes in the display.

Turning on and off → F

Turning the power on

Press ePLAY/PAUSE. Power is turned on and playback starts.

Note

“Err” appears on the display in the following cases: –When you try to play the unit without a disc in the disc compartment. –When you play a disc placed upside-down or a defective disc.

Turning the power off

If no new operations are done within 30 seconds from the end of last operation, the power is turned off automatically. (Auto power off function)

• You can tur n off the power by pressing sSTOP/OFF/CHARGE before it is automatically turned off.

Standby mode → F

When an operation finishes, the unit goes into standby mode until the auto power off function automatically turns off the power. To enter standby mode, press ePLAY/PAUSE to start playback, then press sSTOP/OFF/CHARGE.

Adjusting the sound → G

Volume

Press + to increase the volume. Press - to decrease the volume.

DSL

Press DSL repeatedly for more powerful sound and deeper bass.

: Deep bass is emphasized. : Deep bass is strongly emphasized.

+ 5 hidden pages