Sony WEGA KV-AW21 Operating Instructions Manual
2-886-622-12 (1)
Trinitron Color TV
Operating Instructions
• Before operating the unit, please read this manual thoroughly and retain
it for future reference.
GB
KV-AW21
© 2006 Sony Corporation
P52
A Specifications
KV-AW21P52
Power requirements
Power consumption (W)
Television system
Color system
Stereo/Bilingual System
Channel coverage
B/G
8 (Antenna)
Audio output (Speaker)
Number of terminal
(Video)
(Audio)
Picture tube
Tube size
Viewing screen size
Dimensions (w/h/d)
Mass
Design and specifications are subject to change without notice.
220-240 V AC, 50/60 Hz
Indicated on the rear of the TV
B/G
PAL, PAL 60, NTSC3.58 (AV IN), NTSC4.43
A2 Bilingual B/G
VHF : E2 to E12 /UHF : E21 to E69/
CATV : S01 to S03, S1 to S41
75-ohm external terminal
3 W + 3 W
Input: 2 Phono jacks; 1 Vp-p, 75 ohms
Input: 2 Phono jacks; 500 mVrms
21 in.
545 mm
507 mm
600 × 465 × 481 mm
25 kg
Note
Measured diagonally
Measured diagonally
B WARNING
• Dangerously high voltages are present inside the TV.
• TV operating voltage: 220 – 240 V AC.
• Do not plug in the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through the antenna
and other terminals to ground.
• To avoid battery leakage and damage to the remote, remove the batteries from the
remote if you are not going to use it for several days. If any liquid leaks from the
batteries and touches your skin, immediately wash it away with water.
For your own safety, do not touch
any part of the TV, the power cord
and the antenna cable during
lightning storms.
Do not place any objects on the TV.
The apparatus shall not be
exposed to dripping or splashing
and that no objects filled with
liquids, such as vases, shall be
placed on the apparatus.
Do not block the ventilation
openings of the TV. Do not install
the TV in a confined space, such
as a bookcase or built-in cabinet.
Do not open the cabinet and the
rear cover of the TV as high
voltages and other hazards are
present inside the TV. Refer
servicing and disposal of the TV
to qualified personnel.
For children’s safety, do not leave
children alone with the TV. Do not
allow children to climb onto it.
Do not operate the TV if any liquid
or solid object falls into it. Have it
checked immediately by qualified
personnel only.
Your TV is recommended for
home use only. Do not use the TV
in any vehicle or where it may be
subject to excessive dust, heat,
moisture or vibrations.
Clean the TV with a dry and soft
cloth. Do not use benzine, thinner,
or any other chemicals to clean the
TV. Do not attach anything (e.g.,
adhesive tape, cellophane tape,
glue) on the painted cabinet of the
TV. Do not scratch the picture
tube.
To prevent fire or shock hazard, do
not expose the TV to rain or
moisture.
Install the TV on a stable TV stand
and floor which can support the
TV set weight. Ensure that the TV
stand surface is flat and its area is
larger than the bottom area of the
TV.
Do not plug in too many
appliances to the same power
socket. Do not damage the power
cord.
Pull the power cord out by the
plug. Do not pull the power cord
itself. Even if your TV is turned
off, it is still connected to the AC
power source (mains) as long as
the power cord is plugged in.
Unplug the TV before moving it
or if you are not going to use it for
several days.
C Getting Started
1
Step 1
b
Insert the batteries (supplied) into the remote.
• Do not use old or different types of batteries together.
Step 2
Connect the antenna cable (not supplied) to 8
(antenna input) at the rear of the TV.
• You can also connect the TV to other optional
components (see E).
Step 3
Plug in the power cord, then press 1 on the TV to
turn it on.
• The 1 (standby) indicator flashes green for a few
seconds when turning on the TV. This does not indicate
a malfunction.
Step 4
Select
Confirm
Set up the TV by following the instructions of the
“Initial Setup” menu (see D).
End
Program Sorting/Edit
01
02
03
04
Off
Off
Off
Off
Sorting:
Edit:
PROG
SkipLabel
Exit
Select
Confirm
End
Select
Confirm
Initial Setup
Language:
English
Start Auto Program now?
Yes
No
First please connect
cable/ antenna
Initial Setup
End
Select
Confirm
D
Select
Confirm
Initial Setup
Display this menu next time?
Yes
No
Setting up your TV (“Initial Setup”)
When you turn on your TV for the first time, the “Initial Setup” menu will
appear. You can adjust settings below using the buttons on the remote control
or TV front panel. Press V , v , B or b to select or adjust items, then press
Select the desired menu language.
1
Select “Yes” to preset the channels automatically.
2
To skip automatic channel presetting, select “No”.
The “Program Sorting/Edit” menu enables
3
you to sort and edit the channels (see K).
Adjust the bars on the top and bottom of the menu
4
if they are slanted.
.
To prevent this “Initial Setup” menu from appearing
5
again when you turn on the TV by pressing 1,
select “No”.
To allow this menu to appear again, select “Yes”.
• You can immediately go to the end of the “Initial Setup” menu by pressing WEGA
GATE.
Select
Confirm
End
Loading...