Sony WEGA KV-AR34, WEGA KV-AR25, KV-AR29 Operating Instructions Manual
4-091-356-11 (1)
Trinitron Color TV
Operating Instructions
• Before operating the unit, please read this manual thoroughly and retain
it for future reference.
• Avant de faire fonctionner cet appareil, lisez attentivement le présent
mode d’ emploi et conservez-le pour toute référence ultérieure.
• ,
• ,
KV-AR34
GB
FRMode d’emploi
PR
AR
KV-AR25
© 2002 Sony Corporation
M81
M80
WARNING
• Dangerously high voltages are present inside the TV.
• TV operating voltage: 110 – 240 V AC.
• Do not plug in the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through the antenna
and other terminals to ground.
• To avoid battery leakage and damage to the remote, remove the batteries from the
remote if you are not going to use it for several days. If any liquid leaks from the
batteries and touches your skin, immediately wash it away with water.
For your own safety, do not touch any part of the
TV, the power cord and the antenna cable during
lightning storms.
To prevent fire or shock hazard, do not expose the
TV to rain or moisture.
Do not block the ventilation openings of the TV.
Do not install the TV in a confined space, such as a
bookcase or built-in cabinet.
For children’s safety, do not leave children alone
with the TV. Do not allow children to climb onto it.
Do not operate the TV if any liquid or solid object
falls into it. Have it checked immediately by
qualified personnel only.
Clean the TV with a dry and soft cloth.
Do not use benzine, thinner, or any other chemicals to
clean the TV. Do not attach anything (e.g., adhesive
tape, cellophane tape, glue) on the painted cabinet of
the TV. Do not scratch the picture tube.
Do not open the cabinet and the rear cover of the
TV as high voltages and other hazards are present
inside the TV. Refer servicing and disposal of the
TV to qualified personnel.
2
Your TV is recommended for home use only.
Do not use the TV in any vehicle or where it may be
subject to excessive dust, heat, moisture or
vibrations.
Do not place any objects on the TV.
Install the TV on a stable TV stand and floor which
can support the TV set weight. Ensure that the TV
stand surface is flat and its area is larger than the
bottom area of the TV.
Do not plug in too many appliances to the same
power socket. Do not damage the power cord.
Pull the power cord out by the plug. Do not pull
the power cord itself. Even if your TV is turned
off, it is still connected to the AC power source
(mains) as long as the power cord is plugged in.
Unplug the TV before moving it or if you are not
going to use it for several days.
3
x Securing the TV
To prevent the TV from falling, use the supplied screws, clamps and band to
secure the TV.
20 mm
3.8 mm
screws clamps band
Screw the band to the TV stand and to the
provided hole at the rear of your TV.
or
(1) Put a cord or chain through the clamps.
(2) Screw one clamp to a wall or pillar and
the other clamp to the provided hole at
the rear of your TV.
or
(1) Attach each end of a cord or chain to
the provided holders at the rear of
your TV.
(2) Securely fix the attached cord or chain
to a wall or pillar using an attachment
which can support the TV set weight.
Note
• Use only the supplied screws. Use of other screws may damage the TV.
4
Table of Contents
Installation
Getting Started ..................................... 6
Setting up your TV
(“INITIAL SETUP”) ............................. 7
Overview of Controls
TV front and rear panels ..................... 8
Remote control ..................................... 9
Advanced Operations
Selecting the picture and sound
modes .................................................. 11
Viewing the picture in wide mode.. 12
Listening with surround sound ....... 12
Setting the timers ............................... 13
Viewing Teletext
(KV-AR34M81 only) .......................... 14
Menu Adjustment
Introducing the menu system .......... 15
Changing the “PICTURE” setting ... 18
Changing the “SOUND” setting ..... 20
Changing the “SETUP” setting ........ 22
Changing the Channel Preset
(“CH PRESET”) setting ..................... 24
Additional Information
Connecting optional components ... 27
Troubleshooting ................................. 29
Specifications ...................... Back cover
GB
5
Installation
x Getting Started
1
Step 1
b
b
INITIAL SET
:
Insert the batteries (supplied) into the remote.
Note
• Do not use old or different types of batteries together.
Step 2
Connect the antenna cable (not supplied) to 8
(antenna input) at the rear of the TV.
Tip
• You can also connect your TV to other optional components
(see page 27).
Step 3
Plug in the power cord, then press ! on the TV to
turn it on.
Step 4
UP
ENG ILSHLAN UGAGE
Set up the TV by following the instructions of the
“INITIAL SETUP”menu (see page 7).
6 Installation
x
MENU
PIC
MODE
SOUND
PIP PROGR
PIP PROGR
ENTER
Setting up your TV
(“INITIAL SETUP”)
When you turn on your TV for the first time,
the “INITIAL SETUP” menu will appear.
This menu allows you to change the menu
language, adjust the picture position and
preset the TV channels automatically.
MENU
V/v/ENTER
Installation
Press V or v to select the desired menu
1
language (e.g.,”ENGLISH”), then press
ENTER.
The selected menu language appears.
If the “PIC ROTATION” bar is
2
slanted, press V or v to adjust it,
then press ENTER.
If no adjustment is necessary,
then press ENTER.
The or icon on the screen
flashes while adjusting.
Press V or v to select “YES”, then press
3
ENTER to preset the channels
automatically (see page 24).
The screen will indicate automatic presetting
is in progress.
To skip automatic channel presetting, select
“NO”, then press ENTER.
Press V or v to select “NO”, then press
4
ENTER. The “INITIAL SETUP” menu will
not appear again the next time you turn
on the TV by pressing !.
To allow this menu to appear again, select
“YES”, then press ENTER.
Rotate anti-
clockwise
INITIAL SET
:
INITIAL SET
PIC ROTATION
Refer to this bar when
adjusting.
UP
INITIAL SET
AUTO PROGRAM
START
NOW?
INITIAL SET
PR : 09
:
YS
TV B / G S
LOWV
HF
INITIAL SET
DIS PAL
NEX T TIME?
S
Y T ENUM
HI
UP
ENG ILSHLAN UGAGE
Rotate
clockwise
UP
ES
Y
NO
UP
UP
ES
Y
NO
Tips
• You can immediately go to the end of the ”INITIAL SETUP” menu by pressing MENU.
• You can also set up your TV using the menu system (see page 15).
Installation
7
Overview of Controls
x TV front and rear panels
TV rear panel
qa
C
RLY
123
R
C
B
qs
4
ENTER SELECT
AUTO
PROGR
PROGRMENU
L(MONO) R
2
qd
1
qf
TV front panel
0
Button/Terminal Function Page
1 ! Turn off or turn on the TV. 6
2 1 Standby indicator. –
2 Wake Up indicator. 13
3 Remote control sensor. –
4 PROGR +/– Select program number. –
5 2 +/– Adjust volume. –
6 t Select TV or video input. –
7 AUTO PROGR Preset channels automatically. –
Menu operations
5 SELECT V/v Select and adjust items. 17
6 ENTER Confirm selected items. 17
8 MENU Display or cancel the menu. 17
9 t3 Video input terminal 3. 27
0 i Headphone jack. –
qa Component video input terminal. 28
qs 8 Antenna input terminal. 27
qd T Monitor output terminal. 27
qf t1, t2, t3 Video input terminal 1, 2, 3. 27
9
L(MONO) R
3
8
7
AUTO
PROGR
ENTER
56
SELECT
4
PROGRMENU
3
8 Overview of Controls
x Remote control
qf
qg
qh
qj
qk
ql
w;
wa
ws
wd
PIC
MODE
RESET
DVD
SOUND
SOUND
MODE
231
564
897
0
PIP PROGR
ENTER
PIP PROGR
SURROUND
TV
PROGR
JUMP
MENU
WIDE
MODE
Button Function Page
1
1 ?/1 Turn off temporarily or –
3 a Display the TV input. –
2
4 0 – 9, - Input numbers. –
3
5 JUMP Jump to previous program –
9 SURROUND Select surround mode. 12
4
0 WIDE MODE Select wide-mode (16:9). 12
qa PROGR +/– Select program number. –
5
qf
qg % Mute the sound. –
6
7
qh DVD
qj t
8
wa SOUND MODE Select sound mode. 11
ws PIC MODE Select picture mode. 11
9
wd 2 +/– Adjust volume. –
0
Timer operations
qa
qs
qd
qs Set TV to turn off 13
qd Set TV to turn on 13
PIP operations (yellow label)
6
7
8 PIP PROGR +/
PIP PROGR –
qk
ql SOUND
w; ENTER
Stereo/bilingual operations
2 A/B
turn on the TV.
number.
Display on-screen information.
Select component video input.
Select TV or video input.
automatically.
automatically.
Not function for your TV.
Not function for your TV.
Overview of Controls
–
28
27
–
–
continue
Overview of Controls
9
continued
ea
es
ed
ef
eg
eh
PIC
MODE
RESET
DVD
SOUND
SOUND
MODE
231
564
897
0
PIP PROGR
ENTER
PIP PROGR
SURROUND
TV
PROGR
JUMP
MENU
WIDE
MODE
Button Function Page
Menu operations
wf
wh MENU
Display or cancel the menu.
wj ENTER Confirm selected items. 17
eg V, v, B , b Select and adjust items. 17
Teletext operations (green label)
wg
(KV-AR34M81 only)
wf Enlarge the Teletext display. 14
wg 0 – 9 Input Teletext page number. 14
wk PROGR +/– Display the next or previous 14
page.
wh
wj
wl Show TV screen while 14
waiting for Teletext page.
e; Display Teletext service 14
contents.
ea
Reveal concealed information.
es Display Teletext broadcast. 14
wk
ed Stop Teletext display from 14
scrolling.
ef (red, green, Access a FASTEXT menu. 14
wl
yellow, blue)
eh RESET Set TV to factory setting. 29
e;
17
14
10 Overview of Controls
Loading...