Sony VPCEB4LFX, VPCEB4HGX, VPCEB4GFX, VPCEB4FFX, VPCEB4CGX Replacement Instructions
...
VPCEB Series Optical Disk Drive
IMPORTANT!
PLEASE READ BEFORE YOU START
2.
3.
1.
Replacement Instructions
These easy instructions are intended to guide you through the replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.
damage to the computer's case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible.
o Do not walk around excessively as this promotes static build-up.
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface
of your notebook computer.*
The appearance of the electronic components shown in the illustrations may be different from
the components shipped. This slight difference does not affect the accuracy of these
instructions.
Prepare the Computer
CAUTION: Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Step 1. Place the computer upside
down on a protected surface with the
front edge facing you.
P/N 989201349 Rev. C 1/3
Step 2.
Battery Pack Removal
1) Slide the left battery tab to the
unlock position.
2) With your right thumb, slide the
right battery tab to the left and hold.
3)
Lift the battery with your left thumb
using the notch at the bottom to
remove.
Lift to remove
Optical Drive Removal
(Steps 3-6)
Step 3. The Optical Disk Drive (ODD)
is located on the left side of the unit
as shown.
VPCEB Series Optical Disk Drive
Step 4.
Step 5.
Step 6
.
ODD Disassembly (Steps 7
-9)
Step
8
.
S
tep 9
.
ODD Assembly (Steps 10
-13)
N
OTE:
Identify tabs on the bezel and
Replacement Instructions
Using the enclosed magnetic
screwdriver, remove the two (2) screws
securing the ODD Bay. Put aside the
ODD Bay screws to re-secure the
ODD Bay later in the procedure.
between the ODD and the unit. Gently
pull towards the left to remove the
ODD.
Insert your fingers in the space
Carefully remove the ODD
assembly from the unit.
Step 7. Identify the four (4) side screws
that secure the ODD brackets to the
ODD.
Remove the screws & brackets.
Put the ODD Brackets and screws
aside for transfer to the new ODD.
screws as shown above. Set the old
ODD aside.
Arrange the brackets &
R
B
Step 10. Take the new ODD and bezel
provided in the CRU kit and prepare for
assembly.
P/N 989201349 Rev. C 2/3
tab holes located on the ODD.
Bezel Tab
ODD Tab Hole
Step 11. Align the tabs on the bezel
with the tab holes located on the
ODD. Carefully press the bezel into
place.
Loading...